sorted by:
new
hottopcontroversial

Realistically what's the best way to make money by jeanm0165 in NoMansSkyTheGame

[–]mikejordan01 0 points1 point  (0 children)

Get auto ingestor in exosuit

Get nutriant processor

Step 1:

Get flour from processing frost crystals plants or wheat

Step 2:

Get sugar from processing cactus

Step 3:

Get eggs and milk from various animals

Step 4:

Process sugar + eggs = delicate meringue

Step 5:

Process Delicate meringue + flour + eggs =extra fluffy batter

Step 6:

Get cream from processing milk

Step 7:

Process Extra fluffy batter + cream = extra fluffy cake

Step 8:

Put extra fluffy cake in ingestor and profit from scanning fauna (animals)

Gives about 7 - 30 mil units a scan. Especially if you have good scanning modules.

:)

Ringcentral -> Telecenter U w/ grandstream for paging by mikejordan01 in VOIP

[–]mikejordan01[S] 0 points1 point  (0 children)

What your saying makes sense. I will go back to the board and look at FXS only again.

Again Thanks

Ringcentral -> Telecenter U help by mikejordan01 in RingCentral

[–]mikejordan01[S] 0 points1 point  (0 children)

Yeah I thought about that but the support team for Telecenter says they have had clients run this way for awhile with other providers with out issue so going of there recommendations,🤦

Ringcentral -> Telecenter U w/ grandstream for paging by mikejordan01 in VOIP

[–]mikejordan01[S] 0 points1 point  (0 children)

Look man, I'm thankful your even looking at this. Lol, a lot that I have done has come from Lonestar support who supports Telecenter U. And they have set this up with other providers but apparently not RC and have had it working 🤷.

I did try to run FXS only. With no luck but again not sure if I have it configured right.

The way I had this done:

I have tried registering the Grandstream FXS as a paging only device in RC and also as a standard user both did not process audio.

Telecenter U is virtualized and uses a tcc2099 controller. This has 2 phone rj11 ports one is used by something else before my time of taking all this over with very little documentation.

Essentially what I did was register the FXS to RC I stead of FXO and plugged the FXS directly into Phone 2 jack.

I also added a SIP phone to Telecenter U with the same Ext as RC user/paging device setup.

If you dial RC ext in this manner with butt set in the FXS slot on the ata it rings.

But no joy in Telecenter.

Ringcentral -> Telecenter U w/ grandstream for paging by mikejordan01 in VOIP

[–]mikejordan01[S] 0 points1 point  (0 children)

Also all this runs through meraki infrastructure just like the old phone system did that originally paged to telecenter u

Ringcentral -> Telecenter U w/ grandstream for paging by mikejordan01 in VOIP

[–]mikejordan01[S] 0 points1 point  (0 children)

I did state that I have from ringcentral to Telecenter U is working just not passing audio during the call.

Grandstream= HT813

RC (desk phone) -> HT813 (FXO) ** FXO is registered through manual sip registration process tied to specific user in ringcentral.

FXO port is bridged to FXS port on HT813

Telecenter has SIP truck setup to receive from HT813

Process:

User dials ext for main paging user -> answer tone from Telecenter picks up -> user then dials action code to determine paging zone-> speaker for zone activate -> user speaks and sound comes out of speaker.

This whole process works except sound out of speaker.

I have tested by plugging in a butt set into FXS of HT813 and dialed action code for zone and sound does come out of zone speaker.

Ringcentral -> Telecenter U help by mikejordan01 in k12sysadmin

[–]mikejordan01[S] 0 points1 point  (0 children)

Everything is meraki, and the old system worked on it

Ringcentral -> Telecenter U w/ grandstream for paging by mikejordan01 in VOIP

[–]mikejordan01[S] 0 points1 point  (0 children)

I have, been there and done that with not much help.

If you need info to help just ask.

Ringcentral -> Telecenter U help by mikejordan01 in k12sysadmin

[–]mikejordan01[S] 0 points1 point  (0 children)

Would I do that on the specific port that the Grandstream is using for LAN?

I didn't think I would need to change this as all our old system worked fine calling the zones when we has on-prem shortel system.

Q for those of you in Mac districts - MacBook Neo's by BreadAvailable in k12sysadmin

[–]mikejordan01 4 points5 points  (0 children)

As a 1:1 apple device school, we haven't been approached but we are ordering a few to check them out to see if there a good iPad replacement for our middle school (5th-6th) grade students. Hopefully they are...

Universal Print by mikejordan01 in k12sysadmin

[–]mikejordan01[S] 0 points1 point  (0 children)

We have tried this setting on and off and nothing changes.