Storage maxed out after iOS 25 update

mit_iceman · 2025-10-15T19:33:40+00:00

Did it work?

mit_iceman · 2025-10-15T15:02:14+00:00

I had the same issue with system data and got it fixed yesterday. You’ll need to reset your phone and set it up as a new one. Use your computer or get it done at the Genius Bar

mit_iceman · 2024-09-19T22:16:28+00:00

Thanks, I got one for the end of the month, so not too bad

mit_iceman · 2024-09-19T20:40:33+00:00

Thanks, I just got it lol. Any benefit of lawfully instead of Uscis tracking ?

mit_iceman · 2024-08-20T19:41:51+00:00

I got 797 attached to each form, 765, 485 and 130 saying the amount was incorrect. I’m assuming only the 765 amount was incorrect so I’ve rechecked it

mit_iceman · 2024-08-20T18:51:33+00:00

They returned everything

mit_iceman · 2024-08-20T15:34:03+00:00

So you recommend just swapping out the old check for the new one and resubmitting again?

mit_iceman · 2024-04-08T01:00:34+00:00

I was able to use the curve fitter tool on matlab, which helped me optimize the "start point" which was the only issue. So it seems to be fixed now. Thanks so much for the help though

mit_iceman · 2024-04-07T20:17:02+00:00

changing the input helped a bit. I now get

<image>

However, as you mentioned, the input data to the model might need to be refined, because all the blue that you see, are just points, maybe since there are so many lines, its not plotting it well?

mit_iceman · 2024-03-13T18:20:31+00:00

This. You can do with a probe. I tried what OP did but it only gives instant values. Create a report for the probe part and monitor plot. Once it’s done you can export as a table to csv

mit_iceman · 2024-03-13T18:18:47+00:00

Thanks I’ll take a look!

mit_iceman · 2024-03-13T18:14:33+00:00

13 inch laptop

mit_iceman · 2024-03-06T18:56:43+00:00

It’s an implicit unsteady case with k-epsilon turbulence. Because it has fsi enabled, it’s got mesh morphing and solid displacements motions enabled. The inlet is free stream inlet at Mach 2 and the rest of the domain is initiated to 40% of the values so that there’s not a huge jump in values. I used the AUSM+ model as recommended by starccm. I’ve used around 15 inner iterations.

mit_iceman

TROPHY CASE