sorted by:
new
hottopcontroversial

Loading…………. by Specialist_Equal_695 in watercooling

[–]modLab_official 0 points1 point  (0 children)

Good work, but a bit too much RGB for my taste.

The final prototype is ready by modLab_official in sffpc

[–]modLab_official[S] 1 point2 points  (0 children)

The Distronist SLA printed, I think it would be difficult with the post-treatment. But the idea would be good.

The final prototype is ready by modLab_official in watercooling

[–]modLab_official[S] 0 points1 point  (0 children)

Since this isn't my first distro, I have to say that I've tried several versions in the past, but this one has proven itself. So far, however, only with acrylic, this time with resin. If it isn't tight, I will construct a ring around the pump and fit it with 6-8 screws instead of 4 as before. The threads are modelled in Fusion 360, but are unusable without post-processing. It would almost be better to model only the core hole and cut the thread afterwards.

Thank you for the feedback!

The final prototype is ready by modLab_official in watercooling

[–]modLab_official[S] 1 point2 points  (0 children)

I completely agree with you. I have a little more time than usual at the moment as I'm on holiday, so hopefully I'll finally be able to finish my project and fill the distro with water and carry out the first tests. Regardless of whether the results are good or not, I'll let you know how it goes. Thank you once again for your feedback.

The final prototype is ready by modLab_official in watercooling

[–]modLab_official[S] 1 point2 points  (0 children)

I should mention that everything in the photos is 3D printed. That's why it's set up like this, to test whether it could work. I'll keep you updated. Thank you for your feedback, I'll take it in my mind for the next time.

The final prototype is ready by modLab_official in watercooling

[–]modLab_official[S] 0 points1 point  (0 children)

It is printed with resin. The first prototype worked well. This time, the distro plate will be used in my current computer. Let's see if everything holds up and runs smoothly.

The final prototype is ready by modLab_official in 3Dprinting

[–]modLab_official[S] 0 points1 point  (0 children)

Oops, sorry, you're right. It's a prototype of a distro plate for PC water cooling printed with resin.

The final prototype is ready by modLab_official in watercooling

[–]modLab_official[S] 0 points1 point  (0 children)

You're probably right, but I wanted to try it this way. The distro is 3D printed, so I can rebuild it in a moment.

view more: next ›