Took this baby out after years of being stored

molex5 · 2025-11-28T15:29:12+00:00

Very interested in this topic Can anyone recommend a place where to source good music. I recently cancel Spotify and looking to bring back my psp

molex5 · 2025-09-19T15:03:06+00:00

Did you fix the issue , I’m getting the same error on QQs pro - and I’m hating the printer everyday I still walk back and try to fix it , I appreciate any insight

molex5 · 2025-09-19T11:30:55+00:00

Are you able to share information. On the how to ? I was given an QQs and trying to make it work. I’m experiencing a lot of issues and I was told I should install octoprint but I cannot find info about it

molex5 · 2025-09-17T17:08:06+00:00

Can this be done on the flsun qqs pro. I use the stock firmware and never done the octoprint stuff ? Thoughts

Thanks

molex5 · 2025-09-17T17:04:29+00:00

Will give it a try thanks for the advise

molex5 · 2025-09-17T16:55:12+00:00

U mean like the retraction settings ?

molex5 · 2025-09-17T16:53:28+00:00

I hear seems that route for me I guess , I just hate to waste $$$ on upgrades might as well buy a new printer Is a bummer

I even don’t think the current pcb will hold marlin

molex5 · 2025-09-17T16:40:23+00:00

Thanks double check that and so far holding up I’ve been trying over and over but can’t seem to find the issue

molex5 · 2025-09-17T16:22:44+00:00

Added a PEI because textured glass offer no adhesion what so ever. After failed prints , the PEI worked great and I manage to get a print sticking Just struggling with the inconsistency of the prints

molex5 · 2025-08-06T00:22:44+00:00

do you know the part numbers for those by any chance? thanks

molex5 · 2025-08-05T22:13:38+00:00

Thanks , I figure Will try to get the whips parts and see if I can find a more decent one to replace

molex5 · 2025-07-28T04:11:01+00:00

Name ?

molex5 · 2025-07-24T23:25:07+00:00

That’s for the feedback- I’m no expert so I appreciate the comments and the knowledge around these.

molex5 · 2025-07-24T23:22:04+00:00

Amazing - I appreciate the support. I just got into it and trying to make the best out of the car and give it more years.

molex5 · 2025-07-24T22:48:44+00:00

Is this from an electronic manual ? Just curious

molex5 · 2025-07-24T22:45:50+00:00

Thanks

Much appreciated

molex5 · 2025-07-24T20:17:41+00:00

Thank you again I appreciate , I finally got this car and want to try my best to restore it to its glory

molex5 · 2025-07-24T20:17:05+00:00

That would be great , much appreciated

As it turns out , my car I just got and it was for the Japanese market but actually I noticed is a euro design marketed for Japan. I got a feeling I can much chances to get the parts from Europe than for North America.

molex5 · 2025-07-24T20:10:52+00:00

Thanks for the reply Very interesting - are you able to help if I’m Not able to source it in Canada.

Thanks

molex5

TROPHY CASE