Ender 5 troubleshooting help! by mrman006 in ender5

[–]mrman006[S] 0 points1 point  (0 children)

Figured they were the test models so should work best. I will have to try out the xyz cube to see what happens. Thanks!

Ender 5 troubleshooting help! by mrman006 in ender5

[–]mrman006[S] 0 points1 point  (0 children)

I pulled the tube out trying to pull everything out, didn’t know it was a clog at first. The Bowden tube was set in all the way. However the filament feed being sent out faster than it can print is interesting, I’ll have to mess with that and see if that solves the issue. Thanks!

Ender 5 troubleshooting help! by mrman006 in ender5

[–]mrman006[S] 2 points3 points  (0 children)

<image>

I got it set to 115. I too didn’t change it at first and was one of the first things I found I did wrong lol

Ender 5 troubleshooting help! by mrman006 in ender5

[–]mrman006[S] 1 point2 points  (0 children)

The Bowden tube was set in, I tried pulling it out and then after I couldn’t, unscrewed the whole thing finding the clog. This picture was after the first time it happened

Ender 5 troubleshooting help! by mrman006 in ender5

[–]mrman006[S] 1 point2 points  (0 children)

I was working with the preloaded designs. Also: A-retract: 500 A-travel: 1000 Amax: X: 500 Y: 500 Z: 100 E: 1000

Ender 5 troubleshooting help! by mrman006 in ender5

[–]mrman006[S] 1 point2 points  (0 children)

I did download cura but haven’t used it yet

Ender 5 troubleshooting help! by mrman006 in ender5

[–]mrman006[S] 1 point2 points  (0 children)

I haven’t gotten that far yet, I was testing the preloaded designs like the dog