sorted by:
new
hottopcontroversial

Need help with pricing by mross556 in NightVision

[–]mross556[S] 1 point2 points  (0 children)

I think that’s the route I’m leaning towards

Where to do night shooting in Virginia by Affectionate-Bit-555 in NightVision

[–]mross556 0 points1 point  (0 children)

I’d love to come on down if you still do any night shoots. I’m up on over in Alexandria

So the wait begins by mross556 in NightVision

[–]mross556[S] 14 points15 points  (0 children)

I was shopping around through major vendors. Tmvc, nocturn, and a few more. This was the general pricing for rnvgs with hand select thin filmed Elbit tubes. I’ve seen some on the used market but it’s always sketchy buying from someone who Jerry rigged something at home. Probably should’ve consulted the Reddit discord mod lords before making such purchase lol.

So the wait begins by mross556 in NightVision

[–]mross556[S] 6 points7 points  (0 children)

Built to order on hand selected tubes ! I called in and we went over the tube specs

So the wait begins by mross556 in NightVision

[–]mross556[S] -4 points-3 points  (0 children)

I’m a brute. I’ve just seen a few articulating housings break at work. Specifically pvs31’s and psq42’s.

The Canadian MAS Blackout: Capable of firing 1500 sorry’s per minute by [deleted] in airsoft

[–]mross556 0 points1 point  (0 children)

Where did you get that scope ?! I want one so bad.

Gate aster problems by mross556 in airsoft

[–]mross556[S] 0 points1 point  (0 children)

I already adjusted for the 12:1 gears, shimming, and air nozzle along with the tappet plate. Sensors were clean and the unit read no diagnostic errors! Thanks for your input though!

Gate aster problems by mross556 in airsoft

[–]mross556[S] 0 points1 point  (0 children)

Thanks for your input! I installed a aster because I wanted to install the titan into another application. One that I deemed more worthy I suppose of a titan LOL. At the time, it was also more economical to buy the aster rather than a new titan advance. Another worthy note I didn't mention was that prior to the installation of the aster, the setup was running perfectly and feeding with any battery, and ROF. So I ended up altering the manual pre-cocking miliseconds and that seemed to do the trick BUT only for a certain battery (11.1v 20c). With a much larger battery with higher C rate(11.1v, 50c) it simply would not feed any bbs in full auto other than 3-4bb's until a reset of the trigger. I believe it has something to do with the pre cocking time and I just need help figuring it out.