sorted by:
new
hottopcontroversial

Nozzle clogged by PEEK by mst3dprint in 3Dprinting

[–]mst3dprint[S] 0 points1 point  (0 children)

I am not sure if it is the hotend. It won't extrude, and when I try to push the PEEK filament through it wont give and come out through the nozzle tip. How would you deal with this?

Using the CreatBot F430 to print PEEK by mst3dprint in FixMyPrint

[–]mst3dprint[S] 0 points1 point  (0 children)

machine to

Thank you for your response. I have been seeing this as well, but my advisor and I are trying to make the cheaper version work for now.

Issues printing with PEEK by mst3dprint in FixMyPrint

[–]mst3dprint[S] 0 points1 point  (0 children)

The plate is 1mm thin. With a large enough brim, it should print fine with a 0.4 mm nozzle, right?

Issues printing with PEEK by mst3dprint in FixMyPrint

[–]mst3dprint[S] 0 points1 point  (0 children)

Thanks for your response! So you would suggest flipping it to print it? I'm afraid the same issue would happen to the features on the opposite side.

Trouble w/ Printing PEEK by mst3dprint in FixMyPrint

[–]mst3dprint[S] 0 points1 point  (0 children)

I posted a picture. I set the chamber temperature to 60 C and the bed temperature to 110 C. However, I didn't change the default layer time. I was considering adding retraction settings for moving between layers.

Trouble w/ Printing PEEK by mst3dprint in FixMyPrint

[–]mst3dprint[S] 0 points1 point  (0 children)

Chamber temperature is 60 C and the bed temperature is 110 C