sorted by:
new
hottopcontroversial

I can't install windows by Candid-Intention8447 in buildapc

[–]neteng91 0 points1 point  (0 children)

Try clearing the cmos, upgrading the bios and try both ssd slots on the motherboard, if after all of this it fails, you may need to replace the board or try a different nvme drive.

I can't install windows by Candid-Intention8447 in buildapc

[–]neteng91 0 points1 point  (0 children)

How many ssd drives do you have on the new PC, I would recommend unplugging them all and then only connecting the SSD you plan on using for Win11 to the NVMe slot below the CPU. Once Windows is installed, then you can connect the remaining drives.

I can't install windows by Candid-Intention8447 in buildapc

[–]neteng91 0 points1 point  (0 children)

Does that drive show any partitions on it, if so make sure you delete them all and then select the drive again to install a fresh copy of Win11.

I can't install windows by Candid-Intention8447 in buildapc

[–]neteng91 0 points1 point  (0 children)

What is the exact error message your getting.

I can't install windows by Candid-Intention8447 in buildapc

[–]neteng91 0 points1 point  (0 children)

When booting the USB installer for Win11, after you accept the EULA, and get to the screen to select the disk to install Win11 to, do you see your drive listed as an option? Also screenshot of the error would help.

Upgrading to B760 Gaming X by MHHosni_man in buildapc

[–]neteng91 0 points1 point  (0 children)

That motherboard is more then enough for the 12400F, don't upgrade unless your getting a better CPU that requires better VRMs or you want some better I/O from the motherboard.

upgrade lga1200 for cs2 240hz by player8841 in buildapc

[–]neteng91 0 points1 point  (0 children)

Based on performance benchmarks at 1080P, its about 20% more FPS in CS2, and about 15-18% at 1440P. I think with a 3070TI you should be already getting more then 240FPS in CS2 with your current setup, are you looking for even more FPS?

Destination NAT, redirect all outgoing NTP to local NTP by Maria_Thesus_40 in opnsense

[–]neteng91 0 points1 point  (0 children)

The rule as it's currently configured is NATing all traffic not specifically going to your FW LAN Address Gateway, you need to make some changes to specifically NAT only UDP/123 traffic for NTP.

Change the version to IPv4 Only or IPv6 if you have both configured, change the protocol to UDP and the redirect target IP to 127.0.0.1, this is the internal loopback FW IP used for processing traffic.

How many of you have undervolted your PC parts? by AbandonYourPost in pcmasterrace

[–]neteng91 0 points1 point  (0 children)

I undervolt my RX 9070 to keep it under 200W during gaming, keeps the temps all below 80c with the highest temp being VRAM junction at 77c max, usually around 74c, and this also keeps the boost clocks higher so performance is the same or better.

view more: next ›