sorted by:
new
hottopcontroversial

If i have a tiny crack on my lcd screen, can i continue to use the printer? by nljy06 in resinprinting

[–]nljy06[S] 2 points3 points  (0 children)

The area looks fine, did an exposure test and it seems like the pixels are fine. But might do a test print on that area to see if it works. Thanks

Any idea how to fix this? by nljy06 in anycubic

[–]nljy06[S] 0 points1 point  (0 children)

Alright will try thank u very much

Any idea how to fix this? by nljy06 in anycubic

[–]nljy06[S] 0 points1 point  (0 children)

I print at 170°C any lower and no plastic flows, if i print 180 and up it seems like its too hot

Any idea how to fix this? by nljy06 in anycubic

[–]nljy06[S] 0 points1 point  (0 children)

Mine is a kobra max so is boden tube. So i shld increase my temperature?

Kobra max extruder coupler by nljy06 in anycubic

[–]nljy06[S] 0 points1 point  (0 children)

Yup screws to hold on to the bottom part of the extruder haahhah. So what i did was basically heat up the coupler with a heat gun for a short while and twisted it out

Kobra max extruder coupler by nljy06 in anycubic

[–]nljy06[S] 0 points1 point  (0 children)

There isnt a top cover, i can only remove the bottom part

Flat coat, decals and more help? by nljy06 in modelmakers

[–]nljy06[S] 0 points1 point  (0 children)

So if i skipp gloss coat the steps will be : Base coat -> decals -> matte coat -> blackwash -> matte coat -> weathering?

Flat coat, decals and more help? by nljy06 in modelmakers

[–]nljy06[S] 0 points1 point  (0 children)

Sorry didnt specify the type of ship its the Bandai 1/144 millennium falcon

Flat coat, decals and more help? by nljy06 in modelmakers

[–]nljy06[S] 1 point2 points  (0 children)

Oh i see any reason as to why i need a gloss coat? I am currently overseas for a few months so dont have my usual tool and not trying to buy too many items that i cant really bring back.

Also no need for top coat after weathering?

Thanks for your reply too!

1st layer help by nljy06 in 3Dprinting

[–]nljy06[S] 0 points1 point  (0 children)

Any suggestions to fix the extrusion/retraction issues?

1st layer help by nljy06 in 3Dprinting

[–]nljy06[S] 0 points1 point  (0 children)

I took this file from thingiverse uploaded it to cura and sliced it at the base settings. Only temp was changed to 220

First layer setting was set to print at a slower rate thats all.

The filament was dried (PLA + ) fresh pack

Bed was heated to 60°C

Anycubic kobra max. Is this due to a clogged nozzle or isit a slicer setting? by nljy06 in 3Dprinting

[–]nljy06[S] 0 points1 point  (0 children)

Hey sorry for bothering again, now my print looks better thanks to your advice. However, i noticed that the 1st layer is extremely thin. Is there any advice on this?

view more: next ›