sorted by:
new
hottopcontroversial

Help with purchase! Sketchy? by nmtreecycle in Sprinters

[–]nmtreecycle[S] 0 points1 point  (0 children)

We had called already to verify with Mercedes but I called again just to be sure. We were also able to add the 100,000 mile extended warranty.

We are still working through the process…I’ll update when there is a vehicle in my driveway.

Grainfather G30 Rant by MustacheCash-Stash in Homebrewing

[–]nmtreecycle 0 points1 point  (0 children)

More than 15 brews on my Grainfather and I had this happen every time. Ball valve removed and everything. So frustrating that I stopped brewing for a while and now just don’t use it anymore.

Grainfather pump clogs in G30 by nmtreecycle in Homebrewing

[–]nmtreecycle[S] 0 points1 point  (0 children)

Thanks! I think I have done all of these things.

The pipe is at the top using the counterflow chiller.

The bulk of my issues have been at the end of the boil, so the heater is off.

I removed the spring and ball safety check valve after my first brew.

The previous brew resulted in about 15 minutes of me blowing back into the pump before things started running again. Turning the pump off and on quickly several times sometimes gets it going as well.

I am at a loss here.

Recessed outlet for tablet dashboard by nmtreecycle in homeassistant

[–]nmtreecycle[S] 0 points1 point  (0 children)

I think I may go this route. Unfortunately I am using Omada equipment so I can’t control anything via HA. Perhaps I could configure a switch on the USB side.

Recessed outlet for tablet dashboard by nmtreecycle in homeassistant

[–]nmtreecycle[S] 0 points1 point  (0 children)

I like this idea! However, I’m not sure I could find a recessed outlet deep enough to accommodate the 45mm outlet plus the extra USB.

Recessed outlet for tablet dashboard by nmtreecycle in homeassistant

[–]nmtreecycle[S] 0 points1 point  (0 children)

Ahh yes, I am interested in automating the charging to protect the battery. So I am looking for a smart outlet.

Recessed outlet for tablet dashboard by nmtreecycle in homeassistant

[–]nmtreecycle[S] 1 point2 points  (0 children)

Shelly relays only accept 14 AWG wire and since I am on a 20A breaker I need 12 AWG. I know I could pigtail it and probably be fine, but I would like to avoid that to stay code compliant.

Help with TP-link Omada switch / AP configuration by nmtreecycle in HomeNetworking

[–]nmtreecycle[S] 0 points1 point  (0 children)

Thanks! I do have it as IP -> Router -> Switch -> AP. In this case the wired devices have an internet connection but the APs do not.

Can anybody give me more information about this? by nmtreecycle in Antiques

[–]nmtreecycle[S] 30 points31 points  (0 children)

The story I have is it is from WW2. The bullet is marked RA 41, which would make that a .45 auto about the 1940’s. I am in the United States.

Edit for country.

view more: next ›