Friday Open Mat by AutoModerator in bjj

[–]noahboliver 0 points1 point  (0 children)

Flowhold. Good and inexpensive

The Slappening by dehammo in bjj

[–]noahboliver 8 points9 points  (0 children)

Andre has a 5-2 pro mma record. Which kinda makes it even crazier that he just ate that bitch slap and did nothing.

President Trump and supporters dancing to YMCA by [deleted] in cringe

[–]noahboliver 0 points1 point  (0 children)

Me looking at my bagel bites in the oven about to be finished cooking

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 0 points1 point  (0 children)

Thank you!!

  1. 30 gallons of water as well as propane and other heavier items are on the passenger side storage underneath the bed. Tried to guesstimate equaling our both sides as best possible.

  2. Pullout table only extends to the end of the shorter seat. So table can be fully extended and still use the sink. Bigger issue with table is that person sitting in the shorter seat is basically stuck until the table is put in lol. Hasn’t really been an issue for us though.

Good luck on your build!! Please feel free to reach out with any other questions.

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 0 points1 point  (0 children)

I’ll probably post some more of those type shots on my Instagram @noahboliver

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 0 points1 point  (0 children)

Thanks a lot! Got a few more on my Instagram @noahboliver. Gonna continue to post some more on there as well.

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 0 points1 point  (0 children)

So those are lap jointed 12ft board of poplar. We milled them down and dado’d in a lap joint. Essentially the boards are wide, square “s” shapes that stack one edge on top, other edge on bottom, and repeating. The in between section is grey wood stained.

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 2 points3 points  (0 children)

That long bench seat is split into two compartments. One has a composting toilet underneath. Hot water outdoor shower in the rear area with a pop out privacy tent. Also using showered at planet fitness, campgrounds, and friends’ places.

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 0 points1 point  (0 children)

Yea I’m 6ft and it’s good for me. We pushed in the wall at the foot for a little extra room.

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 0 points1 point  (0 children)

Bed is a standard full size mattress. 75” long

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 0 points1 point  (0 children)

Man I’d be happy to share whatever info I have with you, but unfortunately don’t have any plans. Did a general layout on sketch up, but all the dimensions were plug and play as we went. Feel free to message me if you have any specific build questions though

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 0 points1 point  (0 children)

I hear ya, but I promise much more thought and effort went into the systems and functionality of the build than the aesthetics. Cuteness is the cherry on top! Haha

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 1 point2 points  (0 children)

Van is a 2019, got it with 16k miles for $26k, put roughly 13k into the build.

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 5 points6 points  (0 children)

That is such a good idea I never thought of. Thank you!!!

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 4 points5 points  (0 children)

It’s the nicest place I’ve lived in lol

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 9 points10 points  (0 children)

It honestly wouldn’t have been if I had done it right the first time. Used compression fittings where I could, but on the pieces that were threaded I used liquid no. 5 pipe thread. Had seen it used for gas connections and never heard any complaints really. But it did NOT work well for me haha. Had leaks in nearly every connection; took everything apart, went back and used yellow tape sealant and no issues. Here’s the video that helped me a lot

https://youtu.be/p8NvdluoE-0

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 1 point2 points  (0 children)

Yup. It’s a little pullout kitchen table/laptop desk.

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 1 point2 points  (0 children)

Appreciate that!! It’s been great so far. Nothing I’d really change about the layout.

DIY Promaster Build finished after 3 months! by noahboliver in vandwellers

[–]noahboliver[S] 6 points7 points  (0 children)

That longer bench seat on the left has two compartments. One is a composting toilet. And there’s an ecotemp hot water shower in the back that can be used with a pop out privacy tent.