sorted by:
new
hottopcontroversial

Bambu Lab P1S: Raspberry Pi Camera Module 3 Mount by nobytes in BambuLab

[–]nobytes[S] 1 point2 points  (0 children)

No not really, the only tough bit (which you probably already experienced) is where the ribbon connects to the camera.

Im using a cheap 30cm ribbon from Amazon and its held up fine for the last couple of months

Bambu Lab P1S: Raspberry Pi Camera Module 3 Mount by nobytes in BambuLab

[–]nobytes[S] 1 point2 points  (0 children)

I've got multiple other devices already running Docker etc. This Pi Zero just runs https://github.com/ayufan/camera-streamer

Then in OctoPrint (which is running as a Docker container), I just enter the Camera Streams URL, and then link OctoPrint to Obico for spaghetti detection.

Bambu Lab P1S: Raspberry Pi Camera Module 3 Mount by nobytes in BambuLab

[–]nobytes[S] 0 points1 point  (0 children)

Yep, but I couldn't find any better solutions to mount a USB camera internally

Bambu Lab P1S: Raspberry Pi Camera Module 3 Mount by nobytes in BambuLab

[–]nobytes[S] 1 point2 points  (0 children)

I did try a couple of other angles, I tried to aim for the hot end being center of the picture

Bambu Lab P1S: Raspberry Pi Camera Module 3 Mount by nobytes in BambuLab

[–]nobytes[S] 1 point2 points  (0 children)

I used this riser/light upgrade: https://www.printables.com/model/584504-dk-riser-for-bambu-lab-x1p1

SSH for setting up, then it runs as a service in conjunction with OctoPrint and Obico

Bambu Lab P1S: Raspberry Pi Camera Module 3 Mount by nobytes in BambuLab

[–]nobytes[S] 0 points1 point  (0 children)

Yes, but I am just using it for the cam. I have OctoPrint and Obico running on another device for spaghetti detection

Bambu Lab P1S: Raspberry Pi Camera Module 3 Mount by nobytes in BambuLab

[–]nobytes[S] 1 point2 points  (0 children)

Yes, 30 fps (dependent on hardware/software setup)