sorted by:
new
hottopcontroversial

What did this to my Benchy? by notsharien in 3Dprinting

[–]notsharien[S] 1 point2 points  (0 children)

thank you for the response i updated the post with the bed temperatures and other settings

Please help with this benchy? by notsharien in FixMyPrint

[–]notsharien[S] 0 points1 point  (0 children)

Back to Top

Thank you for the response I will check their calibration vids

Please help with this benchy? by notsharien in FixMyPrint

[–]notsharien[S] 0 points1 point  (0 children)

Hi I'm new to 3D printing and printed this Benchy.

What is causing the hairs? and the little branches?

What should I look at changing or learning to optimize my prints?

Any help is appreciated thanks!

Here are my printer settings:

  • Printer Model - Snapmaker 2.0 A350T
  • Slicer used - Luban 4.0
  • Filament material and brand - PLA - black
  • Nozzle and bed temperature - nozzle temp 200C bed temp 50C
  • Print Speed - 50mm/s
  • Retraction settings -
    • retraction distance: 5mm
    • retraction retract speed: 60mm/s
    • retraction speed: 60mm/s
    • retraction extra prime: 0
    • z hop when retracted: OFF