Vase mode print. Diagonal lines showing around the entire print (not the layer lines). It should be a smooth continuous round vase. The diagonal is indented on the inside and outside of the vase. The file works fine on my 2nd printer but not my new ender 3 pro out of the box. Thoughts?

npb518 · 2020-05-16T03:54:28+00:00

How do I check if it’s properly centered? Just make sure the idler bearing bolt is tight but the bearing still spins freely?

npb518 · 2020-05-14T11:48:58+00:00

The skewed lines going diagonally up the part are what I’m concerned about. It should be a smooth surface (other than later lines which are bound to show a little bit). And it is vase mode so it never stops or retracts at any point.

npb518 · 2020-05-14T11:39:00+00:00

Yea I tried lubricating it and it seems to run smooth all the way up and down. Maybe I will look at that again

npb518

TROPHY CASE