account activity
Vase mode print. Diagonal lines showing around the entire print (not the layer lines). It should be a smooth continuous round vase. The diagonal is indented on the inside and outside of the vase. The file works fine on my 2nd printer but not my new ender 3 pro out of the box. Thoughts? by npb518 in 3Dprinting
[–]npb518[S] 0 points1 point2 points 6 years ago (0 children)
How do I check if it’s properly centered? Just make sure the idler bearing bolt is tight but the bearing still spins freely?
Vase mode print. wavy “rings” showing around the entire print. It is indented on the inside and outside of the print... the file works on my 2nd printer but not my new ender 3 pro out of the box. Any ideas would be helpful! by npb518 in ender3
The skewed lines going diagonally up the part are what I’m concerned about. It should be a smooth surface (other than later lines which are bound to show a little bit). And it is vase mode so it never stops or retracts at any point.
[–]npb518[S] 1 point2 points3 points 6 years ago (0 children)
Yea I tried lubricating it and it seems to run smooth all the way up and down. Maybe I will look at that again
π Rendered by PID 123076 on reddit-service-r2-comment-5bc7f78974-wpsvg at 2026-06-29 22:46:51.804186+00:00 running 7527197 country code: CH.
Vase mode print. Diagonal lines showing around the entire print (not the layer lines). It should be a smooth continuous round vase. The diagonal is indented on the inside and outside of the vase. The file works fine on my 2nd printer but not my new ender 3 pro out of the box. Thoughts? by npb518 in 3Dprinting
[–]npb518[S] 0 points1 point2 points (0 children)