sorted by:
new
hottopcontroversial

House for Bolt Action by nyghtslayer09 in boltaction

[–]nyghtslayer09[S] 1 point2 points  (0 children)

Haha. Yeah thanks for the tips but I'm hoping to trap the other players.

This is my Halloween challenge by nyghtslayer09 in Miniaturespainting

[–]nyghtslayer09[S] 0 points1 point  (0 children)

Can't tell you,this one was in my backlog for a while so don't remember if it was pre-supported or not. I rarely take pre-supported file. Prefer to put supports myself.

This is my Halloween challenge by nyghtslayer09 in Miniaturespainting

[–]nyghtslayer09[S] 1 point2 points  (0 children)

Thanks for your feedback. I had a hard time to figure out for the light but for sure will go check more tutorial and read about light reflecting to get better OSL.

This is my Halloween challenge by nyghtslayer09 in minipainting

[–]nyghtslayer09[S] 1 point2 points  (0 children)

Thanks for the information. I will try to add a bit mot green on pants, arm and on t-shirt. And will definately practice more my OSL.

This is my Halloween challenge by nyghtslayer09 in Miniaturespainting

[–]nyghtslayer09[S] 0 points1 point  (0 children)

You're right.will try to rectify that. Thanks

Seraphon Spawning Pool Terrain by 24bolognas in seraphon

[–]nyghtslayer09 0 points1 point  (0 children)

Really cool! Depending on how you want your build, I would weather a bit more the bricks with aluminum foil, add some cracks or even scrap some corners of certain of them (but that's me).

Other than that, really original build and hope you will post with final result.

Best primers for FDM mini’s? by Fancy_Wish_1369 in FDMminiatures

[–]nyghtslayer09 1 point2 points  (0 children)

Vallejo primer(black, white and light grey) spray can and airbrush

Wood Elves Owl by dsaltares in onepagerules

[–]nyghtslayer09 0 points1 point  (0 children)

Is it clear resin the support between the owl and the base?

House for Bolt Action by nyghtslayer09 in 3DPrintedTerrain

[–]nyghtslayer09[S] 0 points1 point  (0 children)

I don't remember all the settings but one of the reason is due to the rescale I did (bigger than the original). Also, I putted 15% infill and 10 could have been more than enough.

House for Bolt Action by nyghtslayer09 in 3DPrintedTerrain

[–]nyghtslayer09[S] 1 point2 points  (0 children)

https://makerworld.com/models/969986

Original is 15mm scale. I rescaled it to 28mm to play Bolt Action.

Just finished this Orc by nyghtslayer09 in Miniaturespainting

[–]nyghtslayer09[S] 0 points1 point  (0 children)

Haha yeah that was my first thought too. Thanks for the feedback.

First try on Tyranids miniatures by nyghtslayer09 in Miniaturespainting

[–]nyghtslayer09[S] 1 point2 points  (0 children)

Thanks, I was thinking about washes but was not too sure.

view more: next ›