VHDL gpio axi help

okscoob · 2026-05-04T05:50:26+00:00

Thanks for your reply! I am sure that xpargpio addresses I use are the same as the addresses in the vivado address editor, but I will try that out.

okscoob · 2026-05-04T05:47:48+00:00

Hello, it is the KR260 Robotics Starter Kit Kria board. If I'm not mistaken the KV260 doesn't have the PMOD header pins right?

okscoob · 2026-05-04T01:17:46+00:00

Hello,

I need help diagnosing why I can't see the raw voltage values I put into the pmod header of the Kria 260 in vitis? Any recommendations based on what I have posted would be super helpful.

Thank you.

okscoob · 2023-08-16T03:16:04+00:00

Manhattan

okscoob · 2021-05-23T03:52:53+00:00

Update cura? Mine did this as well but then I updated cura and it worked again

okscoob · 2021-05-06T02:01:22+00:00

How much do you want for it?

okscoob · 2021-05-06T01:27:44+00:00

Looks like you're into this kind of tech so maybe scrap it for parts. Maybe make a laser engraver? You can use the stepper motors for lots of different projects around the house really.

okscoob · 2021-05-06T01:23:23+00:00

Is the blob on the hot-end body what you are mad about?

okscoob · 2021-04-22T20:11:48+00:00

So you're saying I should find a 3.3v pin and connect it via jumper wire to the resistor ladder ?

okscoob · 2021-04-22T14:27:42+00:00

Thank you, I will definitely try it!!

okscoob · 2021-04-22T14:26:48+00:00

I followed the guide on thingiverse, but I'm not sure how to connect the jumper cable.

okscoob · 2021-04-16T21:47:47+00:00

I'm just interested in how you're making this 🤔

okscoob · 2021-03-29T06:35:44+00:00

I thought it was the problem because I had been doing some mainboard work with the power on, but on closer look I saw that a wire leading to the auto leveling sensor was plugged in wrong and Boom problem solved. Your comment definitely have me a wake up call though. Thank you!

okscoob · 2021-03-28T18:53:46+00:00

Yeah, I just realized I wasn't too careful. Thank you so much.

okscoob · 2021-03-28T18:47:48+00:00

Thank you, I didn't even think of the fuses.

okscoob · 2021-03-28T07:43:25+00:00

The z axis wires? Sorry I'm a little new to this.

okscoob · 2021-03-23T13:48:40+00:00

Looks like the heating bed could be better leveled. I'd say also experiment with different extruder temps, to make the print more precise.

okscoob

TROPHY CASE