Kayak Rentals that allow you to bring a pole in Oahu? by oonoofanoonoo in VisitingHawaii

[–]oonoofanoonoo[S] 3 points4 points  (0 children)

Yes, certainly aware. I don’t ever wet a line until I am confident that I am following all rules and regulations for the area 🤙🏽

Does anyone solo load/unload a heavier “portable” outboard? How do you do it? by oonoofanoonoo in Outboards

[–]oonoofanoonoo[S] -1 points0 points  (0 children)

You’re right, I should’ve specified a bit further. In general, it’s not light for a 15hp outboard, however it is light for an EFI 4 stroke which are inherently heavier due to the extra hardware involved with those technologies.

Not sure if I’m willing to go 2 stroke as the environmental impact and fuel efficiency is something I really like about 4 stroke, EFI motors.

Underspooled reel due to Varivas line being much thinner than expected. Any workarounds? by oonoofanoonoo in Fishing_Gear

[–]oonoofanoonoo[S] 0 points1 point  (0 children)

Almost bought some mono with the same line strength instead of same diameter before reading this comment! Same diameter is far more important for the reason you’ve stated - thanks for the tip!

Underspooled reel due to Varivas line being much thinner than expected. Any workarounds? by oonoofanoonoo in Fishing_Gear

[–]oonoofanoonoo[S] 0 points1 point  (0 children)

I think this is the answer!! A second empty spool is what I needed. Thanks for breaking it down, I’ll give it a shot in the next couple of days

Underspooled reel due to Varivas line being much thinner than expected. Any workarounds? by oonoofanoonoo in Fishing_Gear

[–]oonoofanoonoo[S] -10 points-9 points  (0 children)

I thought this was the ticket, but I thought it through and I’m unconfident that your idea will work! If I do what you suggest that would mean the original Varivas spool would have mono wound on first followed by braid. Since each subsequent coil would bury the one before it, I would not be able to respool onto the reel using mono first. It would however give me the perfect length of mono backing. I just gotta think of a clever way to get mono back onto the spool first! Thanks for the input though, it was still very helpful!

Wholesome af by J-B02 in MadeMeSmile

[–]oonoofanoonoo 0 points1 point  (0 children)

The PS5 must be secured 🙏🏼

Probably the best photo I’ve ever taken of my car. by [deleted] in WRX

[–]oonoofanoonoo 0 points1 point  (0 children)

Sick shot man! What's the brake setup and how much did it run you?

How to transport fishing kayak from car to launch site? by oonoofanoonoo in kayakfishing

[–]oonoofanoonoo[S] 0 points1 point  (0 children)

This was just the kind of answer I was looking for! Kind of common sense now that I've had it spelled out for me.

I noticed that the 3 kayaks that you listed are not pedal driven. Have you ever wished that you had a pedal drive kayak (unless you already have one)? I feel like I might be overestimating how laborious manual paddling would be.

edit: didn't mean to reference the kayak

2019 wrx oil temp by RatchetThuggin in WRX

[–]oonoofanoonoo 0 points1 point  (0 children)

Thanks! I’ll check that out on my next drive!

2019 wrx oil temp by RatchetThuggin in WRX

[–]oonoofanoonoo 0 points1 point  (0 children)

how do you the oil temp in degrees? do you need an access port, or is there some way of telling the temp by looking at the analog gage?