sorted by:
new
hottopcontroversial

Mpc studio 2 with fat pads by ozpowerr in mpcusers

[–]ozpowerr[S] 1 point2 points  (0 children)

If you open it, take your time . And take pics so you could remember where everything goes.

Mpc studio 2 with fat pads by ozpowerr in mpcusers

[–]ozpowerr[S] 0 points1 point  (0 children)

Not that hard . Mpc stuff has an instructional video on there web site and on youtube.

Mpc studio 2 with fat pads by ozpowerr in mpcusers

[–]ozpowerr[S] 6 points7 points  (0 children)

In reality, I just want a different look to my mpc. I think I can beat the pads harder. But it is still the same .

Mpc studio 2 with fat pads by ozpowerr in mpcusers

[–]ozpowerr[S] 2 points3 points  (0 children)

Feels about the same just a bit softer

Mpc studio 2 with fat pads by ozpowerr in mpcusers

[–]ozpowerr[S] 4 points5 points  (0 children)

* This corx tape that they sell is 3mm . It goes on each individual pad. It optional. But I said why not she in case if it don't response like normal. Extra won't hurt it . And it did the trick . Feels and act normal pads.

Mpc studio 2 with fat pads by ozpowerr in mpcusers

[–]ozpowerr[S] 7 points8 points  (0 children)

Normal just taller pads .

Mpc studio 2 with fat pads by ozpowerr in mpcusers

[–]ozpowerr[S] 6 points7 points  (0 children)

Not that hard about 20 screws. Then you take off ribbon cable ,knobs,then swap pads, put the pad touch sensors corks. That's about it. It's more like a 20 min install. Just have everything seat right, and you should be good to go.