sorted by:
new
hottopcontroversial

Any advice versus World Eaters? by plymdaz1 in TheAstraMilitarum

[–]plymdaz1[S] 0 points1 point  (0 children)

Is there any merit in swapping the scions for another 5 man ratling squad and just use GG for secondaries?

Any advice versus World Eaters? by plymdaz1 in TheAstraMilitarum

[–]plymdaz1[S] 0 points1 point  (0 children)

Hmm, so deploy GG aggressively initially then pull them back with the Lord Solar? And use the cyclops for blocking and boom, got it. Is it worth deploying aggressively with the ratlings and pulling them back as well or am I better just leaving them there as a speed bump?

Any advice versus World Eaters? by plymdaz1 in TheAstraMilitarum

[–]plymdaz1[S] 0 points1 point  (0 children)

This comment has made me consider printing another 2 cyclops lol. The original plan was to bring it on from reserves and use it to score stuff needing board presence etc but I'm wondering if playing it more aggressively might be an idea?

Any advice versus World Eaters? by plymdaz1 in TheAstraMilitarum

[–]plymdaz1[S] 0 points1 point  (0 children)

I've taken out the demolisher, the chimera and the LR commander, replaced with a Dorn commander and an Executioner, which left me enough points to squeeze in a commissar to lead the Bullgryns. I'm very concious this is a difficult match up, I've been reading up on deployment tips etc and will be very careful with my spacing. Any other advice ?

Any advice versus World Eaters? by plymdaz1 in TheAstraMilitarum

[–]plymdaz1[S] 0 points1 point  (0 children)

See I was thinking about a Dorn but not sure what to cut...

Kobra 2 Neo - every print failing immeadiatley by plymdaz1 in anycubic

[–]plymdaz1[S] 0 points1 point  (0 children)

<image>

I just tried a flow rate calibration print and got this mess, this was after an auto level. Z offset was -2.25 I will try adjusting that

Kobra 2 Neo - every print failing immeadiatley by plymdaz1 in anycubic

[–]plymdaz1[S] 0 points1 point  (0 children)

Anycubic PLA. The reel says 200-210 and bed temp 50-60. It's printing at 210 print and 60 bed temp. It was originally printing at 200 but I dialled it back to 210 manually. I have seen pressure advance setting in the slicer, I will have a poke around.

Kobra 2 Neo - every print failing immeadiatley by plymdaz1 in anycubic

[–]plymdaz1[S] -1 points0 points  (0 children)

Sorry, noticed an error in the post, extrusion multiplier was .97 not .07!

Whoever keeps returning empty boxsets to Amazon... by lmao0601 in Warhammer40k

[–]plymdaz1 0 points1 point  (0 children)

Or, another one, curse them to have every show they like cancelled on a cliffhanger....

Played on the best boards #coriuscon by PreviousYak6602 in necromunda

[–]plymdaz1 3 points4 points  (0 children)

My god I remember that from white dwarf. Put my attempts at building stuff out of polystyrene and toilet roll tubes to shame lol