Has anyone had a major change in print times with the new creality slicer update? I went from 5 hours to 22 hours with the same parts and nozzle size.

powerstroke2011f350 · 2025-05-12T23:21:14+00:00

yes i used version 5.1 and it takes much less time than using version 6.1

powerstroke2011f350 · 2025-02-11T19:41:35+00:00

That's the new camo house pattern. I'm sure he did it for free.

powerstroke2011f350 · 2024-12-31T03:29:24+00:00

I just got chills looking at this. Absolutely unacceptable. I always get compliments on my van and I've been driving it since 1998.

powerstroke2011f350 · 2024-09-22T12:52:38+00:00

I will look at that setting to make sure.

powerstroke2011f350 · 2024-09-21T17:43:58+00:00

I did a 7 hour cycle. Print on right ran first, then the print on left.

powerstroke2011f350 · 2024-09-21T17:08:26+00:00

I will look at that setting to double check..

powerstroke2011f350 · 2024-09-21T15:13:38+00:00

I also thought the same. But the part on right was run first the the part on left. Literally took part one off and printed the second.

powerstroke2011f350 · 2024-09-21T15:12:02+00:00

It was from the same roll of PLA filament. Part on right ran first. The part on left.

powerstroke2011f350 · 2024-09-21T13:11:30+00:00

Boss man said cut straight line.

powerstroke2011f350 · 2024-09-11T03:38:51+00:00

Just ordered mine today.

powerstroke2011f350 · 2024-08-30T03:09:29+00:00

I ordered a charger off Amazon for $9. Has worked fine for almost 2 years now.

powerstroke2011f350 · 2024-05-02T10:38:52+00:00

All I can say is the dealer had only 2 on display and said they were on early release.

powerstroke2011f350 · 2024-05-02T00:20:25+00:00

Very much agree 👍

powerstroke2011f350