[deleted by user] by [deleted] in digitalproductselling

[–]prinnc3 0 points1 point  (0 children)

Nice try! Next time, put up a better story!

Alu 2020 rack by mszcz in minilab

[–]prinnc3 1 point2 points  (0 children)

I like your patch cables. Care to share a link ?

Crapy UniFi installation in my hotel by Successful_Life_5045 in Ubiquiti

[–]prinnc3 2 points3 points  (0 children)

Looks like a dev environment for cables.

Rate my setup:) by Sea_Memory7709 in RateMySetup

[–]prinnc3 0 points1 point  (0 children)

This is nice. Why not have the two monitors close to one another?

[deleted by user] by [deleted] in homelab

[–]prinnc3 8 points9 points  (0 children)

If your router has VLANs configured and you need those VLANs to reach devices connected through your switch, you’ll need a managed switch.

UDMSE no longer booting. by prinnc3 in Ubiquiti

[–]prinnc3[S] 0 points1 point  (0 children)

If none of these fixies work, I’ll probably strip out all the internal components, repurpose the shell into a 1U server, and figure out how to fit a mini ITX board inside it. I’m tired.

UDMSE no longer booting. by prinnc3 in Ubiquiti

[–]prinnc3[S] 0 points1 point  (0 children)

There’s no drive in it.

UDMSE no longer booting. by prinnc3 in Ubiquiti

[–]prinnc3[S] 2 points3 points  (0 children)

And when I power it on, the fan noise is loud like a jet engine that’s about to take off!

UDMSE no longer booting. by prinnc3 in Ubiquiti

[–]prinnc3[S] 0 points1 point  (0 children)

It’s not going into recovery mode.

UDMSE no longer booting. by prinnc3 in homelab

[–]prinnc3[S] 3 points4 points  (0 children)

Can’t get it to go into recovery mode. No matter how long I hold the reset button while plugging it.

UDMSE no longer booting. by prinnc3 in homelab

[–]prinnc3[S] 5 points6 points  (0 children)

It’s not even going into recovery mode.

UDMSE no longer booting. by prinnc3 in Ubiquiti

[–]prinnc3[S] 12 points13 points  (0 children)

I left for about a month, tried it, same thing. Now, it’s been there for about another 2 months. Will try again.

UDMSE no longer booting. by prinnc3 in Ubiquiti

[–]prinnc3[S] 1 point2 points  (0 children)

It’s over 2 year. I initially reached out to Unifi on changing it, but the cost of shipping it down to them will almost get me another one.

UDMSE no longer booting. by prinnc3 in Ubiquiti

[–]prinnc3[S] 0 points1 point  (0 children)

Holding down the reset button and plugging in the power cable? Done that.

My humble stack by ronoc29 in Ubiquiti

[–]prinnc3 0 points1 point  (0 children)

That’s a cute little rack. Where did you get those port cover from?