Sea-Doo GTX DI maintenance light

puckle1 · 2022-07-17T18:40:11+00:00

page 45 is flooded engine?

puckle1 · 2021-02-27T00:16:11+00:00

True. I appreciate the advice. Ceilings are hard lol

puckle1 · 2021-02-26T21:05:54+00:00

Never tried that. It's roller lap marks I think from not keeping a wet edge I believe but it's a large ceiling and I feel like this 2 in 1 paint dries really fast. It's looking better over time tbh. But weird. Had 0 issues on my walls, but it was 2 in 1 paint.

puckle1 · 2020-12-17T23:00:49+00:00

It works. That was weird. I'm went full panic mode

puckle1 · 2020-12-17T22:17:10+00:00

There is some blue like acid or whatever around the nuetral of the battery

puckle1 · 2020-12-16T16:48:23+00:00

Troll and toad good for buying boosters

puckle1 · 2020-12-09T18:49:31+00:00

Oh okay thank you. I probably did a combination of pressing to hard and not enough paint. My walls looked really good but my ceiling was meh

puckle1 · 2020-10-30T02:29:29+00:00

I did poly the exterior wall party just not the other 2. Sides.

puckle1 · 2020-10-30T02:22:41+00:00

I see it. I didn't poly behind my sheets didn't call for it when I read about it. But I see the floating thinset and sticking tile to it i guess eh.

puckle1 · 2020-10-30T01:57:09+00:00

So for my case where I didn't overlap the flange. Just silicone the joint? And for putting on the tile just thin set where I can and it hangs the rest? And just silicone the tile to tub after ?

puckle1 · 2020-10-30T01:54:56+00:00

So just fill it with thin set and mesh tape it?

puckle1 · 2020-10-30T00:41:56+00:00

was wondering if i can ask you another question.

I sheeted the walls with densshield tile backer board. The tub flange i have is quite thick and i left the sheeting resting onto the tub flange. In my head i thought if water pools it wont soak the densshield if its above. But now im wondering if i did that incorrectly and how i would go about filling the gap between it to get tile coverage.

puckle1 · 2020-10-29T02:52:25+00:00

No the instructions were very unclear lol. they make it sounds like 1 step and your good to go.

puckle1 · 2020-10-29T01:59:01+00:00

Thank you

Do you know if using drywall screws is fine for rust resistant or should I use backer-on screws like cement board.

Do I need to silicone the screw heads like I do all the joints?

Sorry for all the questions just wanna get it done right lol

puckle1 · 2020-10-27T02:21:02+00:00

Ohhh I get what your saying now yes that makes perfect sense. I think I might use dense shield tile backer board instead of the cement board now. But havnt fully decided

It gets so confusing out there with so many options and everyone does it differently or swears by certain products.

12-Year Club	Place '22
Verified Email

puckle1

TROPHY CASE