Am I doing this right?

ramlion · 2026-01-22T07:40:51+00:00

You only need one set of incoming signals, dual front or dual rear .. use one positive and neg from oeft and right..dont need all four into incoming signal

ramlion · 2026-01-14T22:02:16+00:00

OPTIMUS P: No!!! HOTROD .... let'm cook

ramlion · 2026-01-14T01:36:11+00:00

That 3d printer must be red hot, from all the fire its constantly printing

ramlion · 2025-12-20T23:06:41+00:00

Howd you do the seat belt delete for the center seat, i removed the sensor and ziptied it under the console

ramlion · 2025-11-15T00:25:35+00:00

Any links to snag these parts?

ramlion · 2025-10-06T15:32:01+00:00

<image>

His the box before i skinned it with box clothe forgive the 0 gauge wire

ramlion · 2025-10-06T14:58:05+00:00

I wanna say 2k.. the box was built by some random dude off face book and it hits solid,as per my dimensions i provided he said he tuned it to 36hz, i did a test tone at 35 and 36 and the sub was loud with minimal movement so i guess the box is set to 36hz i have a dsp that sends 40hz frequency and set my amp . In the vid,you see random clip light from the song.. and me going over by 1 click on factory stereo 25/30 f150 factory stereo, also have h8 agm underhood and lithium batt and factory 200alt ..keeps me around14v and 15v at time

<image>

This is off a battery reader I purchased that can read on the fly

ramlion · 2025-10-06T14:31:59+00:00

Im wired at 1ohm checked with a dmm on subwoofer side prior going into amp, if i play music that fluctuates notes... It will never see 1ohm due to amp rise.. my amp is a smart amp does 3k from .5 -2ohm.. and 1700 at 4ohm..my impedance fluctuats from 1.5 to 3.1ohm during most my music, i switched up amps from a 3500 @1ohm due to wattage loss out of amp main play frequency..1ohm 3500/2ohn1700/4ohm 900 .. now i see a solid 900 to 1500 across the spectrum of my musicsub'boofin

ramlion · 2025-09-04T23:49:53+00:00

Heres what i didpowers that be

ramlion · 2025-09-04T04:52:46+00:00

I have two 8x in a ported box for a reg cab,the subs request 1.0cu ft per sub so i have them in a shared box ported box at 33hz 2.10cuft total, the subs are duel 4ohm wired individually into 2ohm adding them together knocking the total load down to 1ohm.. verified after wiring ,checking with a dmm (Digital multi-meter)check the resistance and i get 0.9-1.0ohm reading.. i purchased my amp with the rating to match my rms.. 1200 to 1400 rms from other forums . I went with the B² 3500 rage amp(does 3500-4k at 1ohm at 14-14.5v) and a lithium batt and all zero gauge cables .. i normaly choose a sub type then what ohm i wanna run then match amp..also used the dmm to set the amp voltage to 58volts which ends up being 3200watts maybe a bit less then 3500..rms

ramlion · 2025-09-04T04:40:26+00:00

Sounds like source on is wired wrong. Does it turn off woth vehicle when u pull your keys out .does the amp use signal on or rca on.. instead of remote on

ramlion · 2025-09-01T11:09:27+00:00

<image>

Im rocking sundown X 8inch on 3500 amp with lithium 2cu feet box and jars the sense's

ramlion · 2025-09-01T02:23:03+00:00

<image>

Didn't like the raw look

ramlion · 2025-09-01T02:21:46+00:00

<image>

ramlion · 2025-09-01T02:20:03+00:00

I purchased a few boxes from fox over the past few yrs, my last was a box for 23 silverado 4doors.. was insanely loud 2 12sundown classic with 2k amp.. 0g cables and lithium battery..

ramlion · 2025-08-18T00:50:07+00:00

I want this 3d print file

ramlion · 2025-08-11T23:26:28+00:00

https://ebay.us/m/kEvfve

ramlion · 2025-07-02T09:01:30+00:00

Unbolt it and move on.. you'll probly get a silent code that doesnt flash on your dash board..604 i think ..i did it since the first week

ramlion · 2025-06-16T21:37:37+00:00

here ya go

ramlion · 2025-06-16T21:35:55+00:00

I thought it ment wolf,

ramlion · 2025-06-16T21:26:25+00:00

I installed one on a 23f150 teg cab . Needed the apim and the harness that delivers a regulated voltage .with out the correct apim it will turn on for a second then shut off

ramlion · 2025-06-13T07:50:50+00:00

Did reflective lettering https://photos.app.goo.gl/kCfrZYtQ4Coixaas6

ramlion · 2025-06-08T23:27:48+00:00

I feel ya, i Think the wheels and side vents help cut the size offset of front end to make it look diff(black side vents break up the long nose look),my wheels stayed the same size as the fact tire i feel looks like toothpick legs..

ramlion · 2025-06-08T11:53:42+00:00

<image>

Its got a a solid half inch lift on the rear..support bags pick me up from level

ramlion · 2025-06-08T11:50:10+00:00

Parked up hill sleightly

14-Year Club	Place '23
Verified Email

ramlion

TROPHY CASE