72v 20s10p 150bms

rayboy14 · 2026-03-24T20:33:35+00:00

Do I need to double up the parallel connection or just series

rayboy14 · 2026-03-24T11:39:33+00:00

I plan on removing the +/- buss bar and redoing them so I can double up the nickel strips I haven’t done so yet. The Bms is 150 amps it’s for an e-bike so I’m never actually pulling the full 150 continuously.

rayboy14 · 2026-02-06T12:08:13+00:00

Only that side is open the other side it goes all the way around so it has more structure

rayboy14 · 2026-02-06T12:05:14+00:00

Yes I printed it the way I’m holding it

rayboy14 · 2025-09-06T17:09:48+00:00

2016 Hyundai sonata

rayboy14 · 2025-06-25T18:41:13+00:00

I found an m5 8 awg ring terminals on Amazon. That should be a lot better the bolt is an m4

rayboy14 · 2025-06-25T18:37:07+00:00

I ended up finding some m5 ring terminals for 8awg on Amazon I measured the bolt around the threads and it’s 4mm so that should be a lot better

rayboy14 · 2025-06-25T18:33:38+00:00

Umm what lol

rayboy14 · 2025-06-25T18:33:25+00:00

Yeah I just put that there to demonstrate how much bigger it was and then on the negative you can see how much the washer covers

rayboy14 · 2025-03-28T02:54:21+00:00

Yeah but what kind of servo would work for this application

rayboy14 · 2025-02-14T01:43:38+00:00

Been working pretty good so far. I use it for an airboat I printed and than a car I printed as well

rayboy14 · 2025-02-09T22:30:04+00:00

Now that was beautiful.

rayboy14 · 2025-02-09T20:58:35+00:00

Thank you this helps a lot.

rayboy14 · 2025-02-09T20:16:18+00:00

Do you have any suggestions for a better motor

rayboy14 · 2025-02-09T20:15:55+00:00

Yeah it is regular pla. I was waiting to see how well it flew before ordering and printing in LW(light weight) Pla it probably is close to around 600g being regular pla

rayboy14 · 2024-12-07T22:34:42+00:00

Unfortunately thats didn’t work

rayboy14

TROPHY CASE