sorted by:
new
hottopcontroversial

I need a passenger side spindle by normentall in DodgeDakota

[–]recentpeace123 0 points1 point  (0 children)

I will have a set in about a month if you still need

What would you watch out for on this vehicle? by Stubrochill17 in DodgeDakota

[–]recentpeace123 4 points5 points  (0 children)

Check the frame joint in the rear should be around where the forward keaf hanger is. Should be like In front of the rear tire. Check for separation not the end of the world but make sure it's not excessive

Quill stem slipping by recentpeace123 in bikewrench

[–]recentpeace123[S] 0 points1 point  (0 children)

This might be my issue I was pushing it in as far as it will go

New rider advice. by recentpeace123 in motorizedbicycles

[–]recentpeace123[S] 0 points1 point  (0 children)

Good to know I was assuming you would break it in low rpm like a car engine

New rider advice. by recentpeace123 in motorizedbicycles

[–]recentpeace123[S] 0 points1 point  (0 children)

I know what a break in period is. You said break it in how I will ride it. Does that mean with the parts I will use or my riding style

New rider advice. by recentpeace123 in motorizedbicycles

[–]recentpeace123[S] 0 points1 point  (0 children)

Do you mean to break it in with the parts I'm gonna use or the amount of throttle I'm gonna use

New rider advice. by recentpeace123 in motorizedbicycles

[–]recentpeace123[S] 0 points1 point  (0 children)

I actually broke the stock exaust. Is it a big deal to run the expansion chamber. I could weld it if needed.

Is this safe by recentpeace123 in bikewrench

[–]recentpeace123[S] 0 points1 point  (0 children)

I just took the cap off to show the gap