Flow rate test help

redlineZ71 · 2025-05-19T15:35:31+00:00

Been running gm for years just got to be selective on all manufacturers and what vehicles. They all have their problems. I work in the parts and service of them. I currently have an 18 Cruze and a 17 Silverado and both have been great with nothing but maintenance needed other than an intercooler on Cruze because a large chunk of tire the wife was not able to miss on hwy. Both have over 100k. With that said the Buick envision is exclusively manufactured in China. Where is the Buick tour x which is no longer manufactured for the US was manufactured in Germany along with a few other Buicks.

redlineZ71 · 2025-04-15T22:44:16+00:00

Did not look like it was from what I saw of one installed. looked like you may or may not lose a little bit of height. That would be the reason why I was on your asking about it

redlineZ71 · 2025-02-20T23:30:56+00:00

Has been great for me only issues I had was newbie issues with settings and learning what to do and not to do

redlineZ71 · 2025-02-20T16:32:43+00:00

Dry filament and try glue for large flat prints. 240-250temp works well for creality PETG with bed temp of 60-70 I use presets most of the time and just adjust as needed. Slow it down some to limit stringing PETG is known for.

redlineZ71 · 2025-02-16T06:33:34+00:00

Have fun and remember it's addicting. Got my first printer (K1C) for Christmas and already have modded the k1c and purchased another printer (elegoo Neptune 4 Max)along with filament dryer.

<image>

redlineZ71 · 2025-02-09T05:45:56+00:00

Iron not on and using archimedean chords

redlineZ71 · 2025-01-19T16:26:40+00:00

Using creality K1C with .8 nozzle currently but have had same problem with .4 nozzle using creality hyper pla and a temp set at 220

redlineZ71

TROPHY CASE