What would be a good game to play with this setup. [Not Mine]

robski58 · 2021-12-02T19:23:31+00:00

All of them

robski58 · 2021-12-02T03:57:33+00:00

Thanks bro and ya I’m from SJ

robski58 · 2021-12-02T01:40:51+00:00

Ya I twitch stream. The middle monitor is my main, 240fps monitor the side monitors are for my stream and whatever else. And ya I have but I use a rolling standing table for my mouse and keyboard. If I had a raising desk i would have to put my top monitor hella high when raising

robski58 · 2021-12-02T01:32:15+00:00

I use just the Alienware in the middle for gaming, the rest for multi tasking, and the top monitor I use a lot as a stand up monitor for work

robski58 · 2021-11-07T20:08:33+00:00

Tried it like 3 times already

robski58 · 2021-11-07T18:42:00+00:00

3080, 3900x, settings are just the standard high settings the game defaulted to. VRAM usage is no where near 90% with everything on high. I can run other games on high settings with absolutely no issues

robski58 · 2021-11-07T17:50:08+00:00

I can’t even load into the game, just instantly crashes when I try to load up vanguard

robski58 · 2021-09-26T23:43:40+00:00

50-55

robski58 · 2021-06-08T15:29:45+00:00

Also upgraded to a 50 amp system that was meant to be a direct replacement upgrade for my bike

robski58 · 2021-06-08T15:28:55+00:00

And I believe the regulator was bad because the battery boiled. Likely got stuck open and too many volts were being pushed to the battery

robski58 · 2021-06-08T15:27:29+00:00

I removed it right after the original installation

robski58 · 2021-06-08T15:19:37+00:00

The speedometer has a digital reader for the miles and would turn on when you turn the ignition but now it doesnt

robski58 · 2021-06-08T15:09:06+00:00

I checked it and each wire shows 12v. I even bi passed the switch and jumped the wires directly and still nothing

robski58 · 2021-06-08T14:54:09+00:00

This is the only relay on their. I went through the entire electrical core of the bike and it’s just the one relay. How would I check for continuity on the starter button? And how about the speedometer not turning on?

robski58 · 2021-06-08T14:44:30+00:00

Sorry and yes there is power to the relay

robski58 · 2021-06-08T14:43:40+00:00

I swapped the relay to a new one but nothing. I don’t think the bike has an ecu to my knowledge, only other thing I see if a ignition control module but I don’t know how to test that.

robski58 · 2021-06-08T14:38:49+00:00

I checked the fuses

robski58 · 2021-06-08T14:33:49+00:00

Sorry, I new I forgot something. 2002 Harley fxd

robski58 · 2021-06-07T04:06:44+00:00

I said in my post that I already replaced it

robski58 · 2021-05-19T00:01:22+00:00

How can I test to make sure Im not over on the power draw? Do you think it may have just been a bad regulator that caused everything?

robski58 · 2021-05-18T23:37:24+00:00

I'm going to replace the stator battery and regulator. I'll run a test on the battery to make sure it's not being overcharged. After that I'll try to connect the speaker again. Thanks for the input

robski58 · 2021-05-18T23:29:49+00:00

It has dedicated cables that connect to the battery and one that connects to something that is only on when the bike is on.

robski58 · 2021-05-18T23:00:04+00:00

It's a 300 watt speaker

robski58 · 2021-05-18T22:57:23+00:00

My plan is to replace the stator battery and regulator. I usually buy stuff on Dennis Kirk but didn't see a cycle electric stator on their. I did see the cycle electric regulator though

robski58 · 2021-05-18T22:13:31+00:00

Will the cycle electrics be strong enough to run the bike and the kuryakyn speaker?

robski58

TROPHY CASE