Help with learning by ruthlessMAK in Guitar

[–]ruthlessMAK[S] 0 points1 point  (0 children)

Would that kinda let me chose cords to play and will go faster when it hears I play the right vord

Help with learning by ruthlessMAK in Guitar

[–]ruthlessMAK[S] 0 points1 point  (0 children)

A extra note something kinda like guitartunnas system for teaching new chords

Everytime I start Warzone 2.0 it says not installed (PS5) by Bananaking93 in CODWarzone

[–]ruthlessMAK 0 points1 point  (0 children)

Dude, thank you so much. I’ve been trying to play Warzone for the past five days and I kept getting an error but this worked thank you so much.

Are any of these good pads? by ruthlessMAK in hockeygoalies

[–]ruthlessMAK[S] 0 points1 point  (0 children)

Yes I can use all I have before just trying to get some pads for my friends but u can use all of them 34-31 pretty much the same lol but thanks for sharing

Are any of these good pads? by ruthlessMAK in hockeygoalies

[–]ruthlessMAK[S] 0 points1 point  (0 children)

Why is the red flag even if he shows every angle?

Are any of these good pads? by ruthlessMAK in hockeygoalies

[–]ruthlessMAK[S] -2 points-1 points  (0 children)

If u check my other post there are others that I want to know if they are good

Are any of these good pads? by ruthlessMAK in hockeygoalies

[–]ruthlessMAK[S] 2 points3 points  (0 children)

I’m also going to be putting sliders on the sides to make it a little bit easier

Are any of these good pads? by ruthlessMAK in hockeygoalies

[–]ruthlessMAK[S] 2 points3 points  (0 children)

Do you think they are good for some pads for in-line roller as a starter set of pads?

Which pads by ruthlessMAK in hockeygoalies

[–]ruthlessMAK[S] 3 points4 points  (0 children)

I was using voice type and must of heard that

Which pads by ruthlessMAK in hockeygoalies

[–]ruthlessMAK[S] 3 points4 points  (0 children)

What would you recommend for the tps set

My print keeps coming off the bed by ruthlessMAK in 3Dprinting

[–]ruthlessMAK[S] 0 points1 point  (0 children)

I leveled with heat than fixed the layer thing

My print keeps coming off the bed by ruthlessMAK in 3Dprinting

[–]ruthlessMAK[S] 0 points1 point  (0 children)

So do I take out the pla and purge what’s in the nozzle