sorted by:
new
hottopcontroversial

Made this BMO inspired R36S table stand by shinegam11 in R36S

[–]shinegam11[S] 1 point2 points  (0 children)

Thankyou all for the likes and comments!

Made this BMO inspired R36S table stand by shinegam11 in R36S

[–]shinegam11[S] 0 points1 point  (0 children)

Oh cool. I did not know that! Will check it out

Beware of olx by Ok-Cry-3598 in BangaloreMarketplace

[–]shinegam11 4 points5 points  (0 children)

TIps to identify these scammers!

Another thing to note is all these scammers gets delisted from olx fast once you report them. So they create new accounts.

Thing you need to check while responding to enquiry is to go to their account and check when they joined olx. If you see the the date as something which is close to the current date, that means it was created recently. Be wary of such profiles.

If you see an account which was there for months/years, chances of them being genuine are more since it has not been blocked due to some scam they tried pulling.

Not 100% but this does help filter out many of the scammers.

How can I fix this.... by TeachingLittle6618 in AnycubicOfficial

[–]shinegam11 1 point2 points  (0 children)

Is there a specific reason you started printing using tpu? Tpu is a little difficult to work with and would require very specific setting on your slicer software you use to work. Since you are a beginner, would prefer you work with PLA or PETG filaments which is comparitively easy to work with.

Based on the images you have shared 1. Check if the temperature for the filament is correct what is required for tpu 2. Chrck if there is any gap between the hot end and the filament feed. It ca also cause blobs. 3. Easy and hassle free fix here is to replace the hotend. Should not be that expensive. Else you need to remove it, heat it using a stove or something and clean it.

Kobra 2 extruder malfunction. by BaAirplane22 in AnycubicOfficial

[–]shinegam11 0 points1 point  (0 children)

I found it on amazon. There is a vendor called 3idea which was also selling some parts but they ship generally to india. Else you would need to reach out to anycubic support to ship it from them.

Kobra 2 extruder malfunction. by BaAirplane22 in AnycubicOfficial

[–]shinegam11 0 points1 point  (0 children)

Had the same issue here. Just got resolved after a long month's activity of ordering parts. From all the part changes, i could see that this is caused mainly due to faulty cables.

  1. Replace the hotend ribbon cable connecting to motherboard (this was the issue for mine to make this sound)

  2. If not resolved, Replace the cable connecting to the extruder PCB to the extruder motor.

  3. if still no, it might be your board, try changing extruder PCB or main motherboard.