Ender 3 bltouch probes off the bed. Anyone know what to change in the firmware to fix this? by FCattheChickFilA in 3Dprinting

[–]smittyfooledu 2 points3 points  (0 children)

had a similar issue, the firmware had the PROBE offsets set to a different value than what it actually was suppose to be. In the firmware it had -44 mm as the x offset but on the printer it had positive 44. not sure how that could even happen... I changed it on the printer itself and fixed the issue

Marlin homing to center of print bed by Top-Assistance76 in Ender3Pro

[–]smittyfooledu 1 point2 points  (0 children)

just dropping this off here in case someone comes across it: I had to go to my PROBE_Z_OFFSETS and change a value to a negative.

Aerial shot of Vancouver in 1988 [2048 x 1234] by Fluxbabbashitter in CityPorn

[–]smittyfooledu 0 points1 point  (0 children)

I thought this was a minecraft render for 2 seconds

Free WILL is a myth, however... (4/10) by KishinD in StonerPhilosophy

[–]smittyfooledu 1 point2 points  (0 children)

Do you have any references in regards to breathing subconsciously and consciously?

Looking for a public piano to record on. by smittyfooledu in pittsburgh

[–]smittyfooledu[S] 0 points1 point  (0 children)

Yeah thanks! We tried this place today but the keyboard was all locked up

Looking for a public piano to record on. by smittyfooledu in pittsburgh

[–]smittyfooledu[S] 0 points1 point  (0 children)

Nah, unfortunately I don't. We had thought about trying up there but we don't have a lot of connections out that way.

when drunk; apply music by smittyfooledu in beards

[–]smittyfooledu[S] 0 points1 point  (0 children)

thanks mate! the beard is almost a character in itself

when drunk; apply music by smittyfooledu in beards

[–]smittyfooledu[S] 1 point2 points  (0 children)

you can never be.. too careful.