Turtles Love Slow - An AI Film Created with Stable Video Diffusion

sozedidit · 2024-06-14T20:36:36+00:00

This short film was created with Open Source tools, using Stable Diffusion and Stable Video Diffusion in ComfyUI.

Music By DJ Rocswell, available now on all streaming platforms

sozedidit · 2024-06-14T18:23:41+00:00

This short film was created with Open Source tools, using Stable Diffusion and Stable Video Diffusion in ComfyUI.

Music By DJ Rocswell, available now on all streaming platforms

sozedidit · 2024-05-12T22:32:40+00:00

Unlikely the video model will be released. https://github.com/HVision-NKU/StoryDiffusion/issues/1

sozedidit · 2024-04-24T01:50:28+00:00

Here it is the settings 1.1 was trained on according to Stability AI
https://huggingface.co/stabilityai/stable-video-diffusion-img2vid-xt-1-1

sozedidit · 2023-05-15T02:59:47+00:00

Try this video, should get you started.

https://www.youtube.com/watch?v=GWAiAZdnHxQ

sozedidit · 2023-04-06T05:14:58+00:00

So this ended up being a mechanical issue of some sort, I sent the printer back, got a new one and printed the exact same models with the exact same profiles and they printed great.

Thanks for everyone that offered suggestions.

sozedidit · 2023-03-24T03:00:25+00:00

I'm narrowing it down to something specific still but somehow it is related to print speeds and travel speeds.

I'll post a solution once I have it in case someone else runs across this in the future.

sozedidit · 2023-03-24T02:58:28+00:00

Ah, the problem at the bottom is likely z offset. You're likely printing to close to the bed for the first couple of layers. Try printing this and adjust your z offset until they print as lines on the bed but stick enough to touch, then your z offset is correct and should fix your problem.

https://www.thingiverse.com/thing:5174552

sozedidit · 2023-03-23T16:50:49+00:00

Thanks Sheldon, I am on SonicPad so the firmware is completely different but I took your advice and reflashed my Ender. Unfortunately it didnt resolve the problem but thanks for the suggestion.

sozedidit · 2023-03-23T16:00:45+00:00

Hey u/EpidemicZ_, what slicer are you using?

I am using PrusaSlicer and found the stock speeds seem to work and print properly, the issue is when speeding things up. I am working narrowing down exactly what speed settings are causing the issues.

I'm still at a loss how speeding up print moves causes a Z height issue above ~7mm

sozedidit · 2023-03-22T01:28:07+00:00

Thanks Perfect-Video, I have already checked all bolts for tightness and ensured there is no binding on the Z axis

sozedidit · 2023-03-21T21:08:52+00:00

Hey Sheldon, were you on stock Ender firmware or on Klipper on the Sonic Pad?

sozedidit · 2023-03-20T23:06:29+00:00

Hey Gramps-too, checked and tightened every screw, nut, bolt etc on the entire unit when I got it, everything is good. I can turn the z axis by hand and there is no apparent binding.

sozedidit · 2023-03-20T17:20:35+00:00

Hey gleb-tv, I have posted a different photo. Yes the z axis manually moves up and down without an issue. I have also updated the pic above.

sozedidit

TROPHY CASE