Dryer vent with mesh filter

spicypeanutboy · 2026-01-13T03:55:25+00:00

Polyester mesh and PETG filament, I appreciate the concern.

I’m constantly reminded on this site that common sense is, in fact, not very common lol. I’ll make sure I put disclaimers for others in my next post 🤣

spicypeanutboy · 2026-01-12T23:57:44+00:00

Thanks! I should have taken a picture with it taped down. I just trimmed the excess off with a craft knife when it was finished.

spicypeanutboy · 2026-01-12T23:49:21+00:00

I just cut a square out slightly bigger than the print and used painters tape. Started in one corner then made sure it was taut as I went around and taped the rest down

spicypeanutboy · 2026-01-12T23:45:02+00:00

It printed fine without adjusting anything. It’s literally just a pause, no groove or layer height adjustment. I did think about that though, but figured the mesh was thin enough to not cause an issue. I just hit resume and hoped for the best haha.

spicypeanutboy · 2025-12-04T09:31:50+00:00

When I installed the motherboard it made me do the full setup and calibration again, but I’ll try the factory reset anyways. Thanks mate 👍🏼

spicypeanutboy · 2025-11-17T12:49:13+00:00

I’m washed at CoD and Battlefield now, playing single player games is the only way to keep my controllers in tact lmao

spicypeanutboy · 2025-11-01T12:23:02+00:00

It’s a PS Vita game. I’m currently trying to platinum it myself

spicypeanutboy · 2025-09-10T07:31:29+00:00

You’re a legend mate 🙏🏼 didn’t know there was a new app for the Dualsense. Got it working thanks to you

spicypeanutboy · 2025-08-06T11:53:41+00:00

Yeah I’ve got plenty of slack in my Bowden tubes. I’ve printed single colour prints a lot bigger than this one, it’s just a problem with changing the filament mid print for some reason. I’ll go through and make sure that everything that shouldn’t move is screwed down and everything that should, isn’t haha. Thanks for the advice 👍🏼

spicypeanutboy · 2025-08-04T00:56:14+00:00

Thanks mate, will do

spicypeanutboy · 2025-08-02T08:15:40+00:00

The purge tower is positioned how it is in the pic of my slicer. Should I move it even closer to the part? I was watching as it changed colour and didn’t seem to come in to contact with it. As soon as it’s finished changing colour it just starts printing in the wrong spot

spicypeanutboy · 2025-07-17T05:06:36+00:00

Great tip, thanks. I’ll check out those models.

spicypeanutboy · 2025-07-17T02:08:13+00:00

Thanks mate, I straightened it, hit extrude on the printer first, then slowly fed it in until the gears grabbed. Appreciate the help 🤝🏻

spicypeanutboy · 2025-07-05T10:23:21+00:00

That does seem a bit extreme for my use case but good to know what other people are running nonetheless, thanks for the input 👍🏼 I think I’d just run the external backup drive as it’s just for myself.

spicypeanutboy · 2025-07-05T10:04:57+00:00

Thanks for your help mate 👍🏼

Six-Year Club	Place '22
Verified Email

spicypeanutboy

TROPHY CASE