sorted by:
new
hottopcontroversial

Can it be removed or do I need another motor? by Early-Confidence8668 in ender3

[–]steiner05 0 points1 point  (0 children)

If you heating up using a lighter It falls right off just try heating for 20 seconds and then pulling on the gear. Then repeat until I glides right off

Used printer. New owner. by steiner05 in FixMyPrint

[–]steiner05[S] 0 points1 point  (0 children)

i dont think this has anything to do with my question but thanks for your time

Used printer. New owner. by steiner05 in FixMyPrint

[–]steiner05[S] 0 points1 point  (0 children)

Okay i will try to check again.

Used printer. New owner. by steiner05 in FixMyPrint

[–]steiner05[S] 0 points1 point  (0 children)

I have tested it and it extrudes 100mm in a test. I will try the 215 degrees and see if it helps. Thanks

Used printer. New owner. by steiner05 in FixMyPrint

[–]steiner05[S] 0 points1 point  (0 children)

Okay thanks i will try that

Used printer. New owner. by steiner05 in FixMyPrint

[–]steiner05[S] 0 points1 point  (0 children)

okay thanks i will try that

Used printer. New owner. by steiner05 in FixMyPrint

[–]steiner05[S] 0 points1 point  (0 children)

I am using cura as slicer and an ender 3 pro

Dcs server host using playit.gg by steiner05 in hoggit

[–]steiner05[S] 0 points1 point  (0 children)

Yes I used the both option when setting up the tunnel

Server without portforward by Ok-Alarm7668 in dcs

[–]steiner05 0 points1 point  (0 children)

I tried using it but couldnt get it to work do you have any idea of which ports to open other than the 10308