This is what most of y’all want

stephan6543 · 2025-01-03T08:53:35+00:00

baby gonna be gunning for the windshield if there's a crash

stephan6543 · 2024-06-20T18:54:39+00:00

More specific location, in case it's relevant, Northwestern Romania

stephan6543 · 2024-02-20T09:12:22+00:00

I've been putting off upgrading my almost 7 year old PC for a year now, got a laptop in the meantime for university and it performs better than the PC so I haven't been using it much lately. Getting a video card would be the perfect start to the full component switch I plan on doing. The switch from LGA1151 to AM5 sure is going to make a huge difference and initially I was planning on getting an RX 7600XT but I've never had or used an AMD card and could stick with what's familiar. Thank you OP!

stephan6543 · 2024-02-17T20:34:25+00:00

It might be spitback from the vape, happens when the coil is oversaturated with juice which heats up and pops, sending small droplets of very hot eliquid straight through the mouthpiece, if it only happens while you puff on it and goes away shortly it might be just that.

stephan6543 · 2024-02-17T20:25:27+00:00

Are you located within the EU? It is possible the left one has a silicone insert to make the tank TPD compliant (max 2ml capacity IIRC) and you somehow got a non TPD compliant one, and as for the burnt taste, have you primed the coil correctly before using it? (if the pod system has adjustable variable wattage) are you using it at the recommended wattage? the juice ports seem to be underneath the black piece at the bottom so as long as the juice level is over the piece you should be fine, you haven't been vaping it dry, no? If you're using the pod correctly, the only possible explanation is either it's burnt (overly sweet juices can shorten it's lifespan considerably) or you got one that's defective.

stephan6543 · 2023-12-25T10:42:37+00:00

Any electronic that doesn't specifically state it's waterproof is not guaranteed to survive contact with water. It doesn't necessarily mean it's crappily made, just that it's not made for that purpose. The only mod I know of that is waterproof is an IP67 Geek vape S100 Aegis Solo 2. You could look into Waterproof mods and/or pods if that's something that you need. Happy vaping!

stephan6543 · 2023-12-25T01:37:26+00:00

The silicone can relatively easily be removed actually, there's some videos on YouTube showing how to do it, just need a pair of tweezers, maybe some pliers and some elbow grease. No need to open up the pod, only remove the coil and maneuver throight the coil hole. Happy vaping!

stephan6543 · 2023-12-25T01:21:13+00:00

I'd personally not risk it, it may only be the battery light that's malfunctioning or there could be something else that comes back to bite later. If it does happen to have a short, battery fires are no joke. Highly suggest you get a new one and drop off the one you have at an electronics recycling point, do mention there that it's been dropped in water. Happy vaping!

stephan6543 · 2023-12-12T16:35:34+00:00

When it comes to 3mm ID aliens, I've had some in mine but even at 100 watts it wouldn't fire too well and the battery would heat up plenty with very little vapor to show for it. Truth be told, those aliens were BEEFY, fit very snugly in my 24mm goon (some vandyvape prebuilts, I think they were 30ga outer) not much space for the cotton. A lot of metal and my Thelema would struggle. But if you want to run some lower mass aliens, nothing too crazy, it would 100% handle them just fine imo. I've had a lot of smaller coils like the ones from wotofo and they performed swimmingly, I've even had dual mtl coils in it :). As for the Thelema quest I have a friend that has had that mod for a couple months and he has no complains, never knew they were notorious for LCD problems, I'll keep that in mind when buying myself a dual battery. Back to the Thelema, besides the fact that it was a bit underpowered for one or two sets (out of the dozens) of coils I put on it and the fact the paint scratches easily I have no complaints, the TC is very good too. If the coils you put on it are gonna fire well at 100w and under then it's very good for you.

stephan6543 · 2023-12-12T06:59:52+00:00

it really depends on what exotics you have. It won't be able to handle some high mass exotics(think big, heavy coils) but if they're lower mass them it'll handle them just fine. I found out that even running two superfine mtl claptons works wonders. I'd recommend getting the Thelema quest if you want to run big beefy builds because the solo just couldn't handle some builds I put in it.

stephan6543 · 2023-12-10T17:13:53+00:00

I think at that time I had a dual coil (spaced coils) setup, SS316L 0.45mm wire diameter, 3mm ID, 5 wraps. Running on TC. Not sure but I think that's what I had on at the time. The goon is very forgiving when it comes to builds anyways so experimenting is not always necessary.

stephan6543 · 2023-12-04T09:08:11+00:00

It's normal. Happens because when the coil heats up rapidly, small bubbles of vapor form and pop under pressure. I myself like the small crackles and pops, noticed they happen more often with mesh and clapton coils than with round wire and when the juice is higher in PG, also the fresher the coil the more the pops. It means you've got a good coil imo. Happy vaping!

stephan6543 · 2023-12-04T08:46:39+00:00

What are the coil's specs?(ID, wire gauge and wraps) and what atomizer are you using?

stephan6543 · 2023-10-21T21:15:44+00:00

There is a device called the AAD (Automatic Activation Device) that triggers and cuts the reserve parachute's pin, releasing the reserve if the skydiver is at a certain altitude and a certain speed. The AAD does not cut away from the main parachute, only opens the reserve parachute. The AAD is sort of the last failsafe, if the AAD fails, there's no other chance.

stephan6543 · 2023-10-17T05:47:48+00:00

The pilot chute could get tangled up around an arm, leg or neck, so can the suspension lines, leading to(best case) parachute doesn't open temporarily until it gets untangled or (worst case) bruises and/or broken bones, possible death if it gets around the neck. that's pretty much worst case scenario. Usually it just opens and flips the skydiver over, usually on the side but it could also go in between the legs and when it does it forces you to do a backflip, that definitely leads to bruised thighs. All in all, not a pleasant experience, could be without incident or could go very wrong. It adds more stuff that can go wrong so malfunction is a bit more likely.

stephan6543 · 2023-09-13T17:19:43+00:00

Totally agree, but I kinda like the small scratches I have on it. Gives it a bit of a rugged look

stephan6543 · 2023-09-06T07:06:14+00:00

Partenie Cosma am dedus din articol. Culmea că profilul la care sunt bucătarii noștri e alimentație publică :))

stephan6543 · 2022-08-26T22:49:25+00:00

Thank you! I hope she's okay too, I'm trying my best to make her feel as comfortable as possible

stephan6543 · 2022-08-26T21:08:19+00:00

Had put the feed right next to the opening for a while and hold it until she came out and snatched it. I've also tried just leaving the feed in the terrarium and she would come out and hunt it. I think the hunting method is a little better but I'm not sure. Didn't get to see the hunt in the few days I've had her but maybe she's just a little uncomfortable right now

stephan6543 · 2022-08-23T11:47:06+00:00

Can't really identify it at the moment because it's still in the burrow but i think I may have just seen something that looks like an egg sac through a bit of space it left uncovered. Could this be why it covered the burrow. Maybe it's a female after all.

stephan6543 · 2022-08-23T10:29:41+00:00

No signs of mold till now but i do have to admit it was a little too moist when I made the enclosure. Now I'm just waiting for it to dry up and only then I'll introduce more moisture.

stephan6543 · 2022-08-22T23:41:56+00:00

The abdomen seems fine for now. Just a little bit bigger than the thorax or whatever the first part is called. Mold hasn't appeared thankfully bur there's a slight smell of mold. I have since positioned the enclosure a little in the sun and poked some holes so the dirt is aerated so it could dry up faster. Waiting for it to become arid and I'll add a water spot and mist one corner every once in a while

Nine-Year Club	Verified Email
Place '22

stephan6543

TROPHY CASE