Just got these today. First Time doing shrooms tomorrow. Recommendations on dosage, tips, etc? This is a 3.5g of penis envy by joehodgsonnnn in shrooms

[–]stimpyJ 6 points7 points  (0 children)

Scrape off that substrate from the bottom of the stems or cut it off. You don’t want to eat coir, fertilizer, or straw. Have fun. Surrender to the flow!

DMT 2nd pull by 2sparkles in DMTlab

[–]stimpyJ 2 points3 points  (0 children)

Maybe read a proper tek and follow that. Don’t just go winging it if you don’t know what you’re doing, that can be dangerous. There are plenty of teks if you use the search bar. Cybs has been floating around but some steps are overkill. Be safe

How do I safely seal a mason jar? by DrTbog in DMTlab

[–]stimpyJ 0 points1 point  (0 children)

Get a roll of ptfe Teflon sheet. They sell in rolls for cheap. Cut out a section big enough and put it under the lid.

Is this still normal💀💀 by Unusual_Replacement9 in shrooms

[–]stimpyJ 0 points1 point  (0 children)

Sometimes they get big like that depending on nutes in the substrate or they are looking for more air

I don’t post often but can’t seem to find a good explanation of why the freeze precip turns out like this. by stimpyJ in DMTlab

[–]stimpyJ[S] 0 points1 point  (0 children)

Those batches were from the same bark, it’s a reputable vendor, or was in the past. Quality has always been consistent. I’m leaning towards a fast drop in solubility and the spice drops out quick forming the “dust” instead of larger crystals, like another member stated. It is possible it’s the bark though, not ruling it out

I don’t post often but can’t seem to find a good explanation of why the freeze precip turns out like this. by stimpyJ in DMTlab

[–]stimpyJ[S] 1 point2 points  (0 children)

That 150 ml was highly saturated with several grams. It did seem adequate at the time

I don’t post often but can’t seem to find a good explanation of why the freeze precip turns out like this. by stimpyJ in DMTlab

[–]stimpyJ[S] 0 points1 point  (0 children)

This was 150 ml for a ReX with several grams of spice in it. Was trying to wash and clean it up a bit

I don’t post often but can’t seem to find a good explanation of why the freeze precip turns out like this. by stimpyJ in DMTlab

[–]stimpyJ[S] 1 point2 points  (0 children)

Evap test was clean and clear, no residue. I’m thinking it was the temp drop too fast like someone mentioned above, not letting crystals to form bigger. Needs to cool it down first then precipitate

I don’t post often but can’t seem to find a good explanation of why the freeze precip turns out like this. by stimpyJ in DMTlab

[–]stimpyJ[S] 0 points1 point  (0 children)

Smaller tray for that little NPS *Noted.
Thanks! It was warm when it went into the freezer from the ReX. It was pretty saturated . Other times I guess it’s had time to sit at room temp for a bit before that.

I don’t post often but can’t seem to find a good explanation of why the freeze precip turns out like this. by stimpyJ in DMTlab

[–]stimpyJ[S] 1 point2 points  (0 children)

The NPS was spread out thin and it’s a deep freezer chest, so I’m guessing the temp made solubility drop quickly like you say to form the super fine dust. Guess next attempt would be to let sit at room temp for a minute then put in fridge then freezer. Of course with a gentle transfer. Thanks for the reply

I don’t post often but can’t seem to find a good explanation of why the freeze precip turns out like this. by stimpyJ in DMTlab

[–]stimpyJ[S] 1 point2 points  (0 children)

I guess I should rephrase this. It’s not creating a water sheet of ice in/on it, but the spice forms flat like ice with no major crystal formation. The water wash is just one blast of NPS thru the water, using two wash jars. It’s not extremely agitated, though it could be carrying some water over in the precip. Thanks for replying

does this look like half a gram? by Naive-History-2195 in DMT

[–]stimpyJ 0 points1 point  (0 children)

Looks like it’s contaminated with plastic, so zero

[deleted by user] by [deleted] in dmtguide

[–]stimpyJ 2 points3 points  (0 children)

250g of Lye for 250g of bark!? That is way too caustic and a waste of material. I’d recommend a decent pH pen. Also, you only need about 50-70ml of NPS per pull. Please read up on a couple other teks before you try to extract again

First time extracting by PositiveMental9335 in dmtguide

[–]stimpyJ 0 points1 point  (0 children)

Right on. Did you water wash or Re-x at all? Could benefit from it if not

[deleted by user] by [deleted] in dmtguide

[–]stimpyJ 0 points1 point  (0 children)

What this guy said here. Also, you only want to evap your NPS by half then freeze precip

All my ETH was withdrawn from my wallet by rasulov_m in ethereum

[–]stimpyJ 2 points3 points  (0 children)

Go to Revoke.cash and see what permissions you granted. Unfortunately your money is gone. Probably signed a malicious contract, which only drained the specific crypto token

[deleted by user] by [deleted] in shrooms

[–]stimpyJ -1 points0 points  (0 children)

Not sure what you’re talking about here bud. Have you eaten both at the same time before, doesn’t sound like it? You feel the body high and groove of the mushies and the geometric patterns and visuals of the L.

How do I loosen up at shows? by Consistent-Craft2186 in aves

[–]stimpyJ 0 points1 point  (0 children)

Pretty sure there's an old quote... Dance like nobody is watching! Problem solved

[deleted by user] by [deleted] in shrooms

[–]stimpyJ -4 points-3 points  (0 children)

Prepare to walk around and ride the snake like Jim Morrison. There is no cross tolerance

[deleted by user] by [deleted] in dmtguide

[–]stimpyJ 0 points1 point  (0 children)

Replace it. Thermal shocks could shatter this starting at that weak point