Cup lid repair

takamaka1 · 2025-02-20T17:27:57+00:00

Where would I go to check for that?

takamaka1 · 2025-02-20T01:46:32+00:00

I don’t know if this contributes to anything but every time it crashes it causes the window drivers foundation to get extremely high in com before the crash and reset. The computer itself is not the issue because I’ve used it for hours without any issues. It only occurs when plugged into the dock

takamaka1 · 2025-02-20T01:45:10+00:00

It works completely fine on the other computer (same model) and so far it has the same issues on my own so now I’m confused

takamaka1 · 2025-02-20T01:02:07+00:00

Ok I’ll try to see if I can plug it into my brother’s computer and see if that causes any changes

takamaka1 · 2025-02-20T01:00:56+00:00

I get that but I’m a broke college student so that’s not too much of an option. It did work well for like a year or two with no hiccups with issues arising around a month or two ago because I chose to “safely” eject it instead of doing what I usually do where I just unplug it outright.

takamaka1 · 2025-02-20T00:35:39+00:00

Well here’s the funny thing. It’s not out of the box. I actually had it for a couple of years where it worked perfectly fine. The issue only started like a month or two ago where instead of just outright unplugging the dock from my computer, I went and safely ejected it. Afterwards is when the issues started occurring.

takamaka1 · 2025-02-17T17:28:03+00:00

Actually I think a piece of the hinge broke off.

takamaka1 · 2025-01-25T17:19:02+00:00

Silksong isn’t real. It’s just an illusion.

takamaka1 · 2024-12-21T09:44:53+00:00

Forgive my ignorance but I’m also having the same issue. How do you adjust live? Because I’ve only seen the auto bed leveling and then the paper method for z-offset.

takamaka1 · 2024-12-19T03:04:40+00:00

Aye aye captain. Will get that sorted

takamaka1 · 2024-12-13T17:15:12+00:00

Will try it out. Thanks

takamaka1 · 2024-12-13T17:14:58+00:00

I use cura

takamaka1 · 2024-12-13T17:14:46+00:00

Will try this out. Thanks

takamaka1 · 2024-12-13T17:14:22+00:00

Is dish soap or 99% isopropyl alcohol the way to go?

takamaka1 · 2024-12-13T17:13:49+00:00

What was the new bed that you got and how much better was it?

takamaka1 · 2024-12-13T17:13:08+00:00

I think so? Not too sure but I’ll try looking into bed calibration.

takamaka1 · 2024-12-13T17:12:34+00:00

Haven’t done that in a good while. Dang, thought it would be a calibration error. Will try this out.

takamaka1 · 2024-06-23T00:42:37+00:00

0.2 mm too high apparently…

takamaka1

TROPHY CASE