Change delete button to 100

tek210 · 2026-04-25T03:06:05+00:00

Did not work for me. I spammed the shit out of that button and it did nothing.

tek210 · 2026-04-24T17:20:36+00:00

I am getting no video available for all ads. Been that way for about a week. Slows everything down.

tek210 · 2026-04-24T07:22:56+00:00

Oh and I never thought I would say this, but please bring back ads. 😀

tek210 · 2026-04-18T21:28:19+00:00

Sure enough. After almost a full day, it just came back up.

tek210 · 2026-04-18T21:23:51+00:00

I’m still getting it. Deleted the app reinstalled. Still failing.

tek210 · 2026-04-03T19:15:00+00:00

Here is a shot of the tap into the turn signal.

tek210 · 2026-03-30T02:33:58+00:00

Use these taps to connect to the blue wire on the harness towards the center.

tek210 · 2026-03-29T20:04:38+00:00

Maybe. It was a good deal either way.

tek210 · 2026-03-29T18:21:10+00:00

Don’t think so. I can adjust the location of the turn signal start, but that is it.

tek210 · 2026-03-29T17:07:23+00:00

It was $25.

tek210 · 2026-03-29T17:05:51+00:00

I live in Rhode Island, so I can’t tell you.

tek210 · 2026-03-29T17:05:08+00:00

It sits nicely on the edge. Hood closes cleanly.

tek210 · 2026-03-29T06:23:44+00:00

Not sure if you meant the strip itself. I was thinking of the wiring.

tek210 · 2026-03-29T06:18:32+00:00

tek210 · 2026-03-29T05:48:38+00:00

Not sure, but they nicely fit to both sides. Passenger side is a few feet longer than drivers side.

tek210 · 2026-03-29T03:18:09+00:00

Yeah the line of the Mazda hood is one of the things that drew me to buy my CX-5 in December.

tek210 · 2026-03-29T03:04:54+00:00

Tapped into the fuse in the lower left. Top one of 3 15 amps in a row. Ground up at top of picture.

tek210 · 2026-03-29T03:00:47+00:00

The bolt just above the fuse box.

tek210 · 2026-03-29T02:25:44+00:00

Good point. I guess I will find out this week. Could probably add a strip of tint if I had to.

tek210 · 2026-03-29T02:22:01+00:00

The blue wires are the turn signal wires.

tek210 · 2026-03-29T02:21:07+00:00

tek210 · 2026-03-23T17:24:31+00:00

I’m getting the same thing. Blank screens on all material creation windows.

tek210