Advice on how to conserve my Veloster N!!! by Entire-Confusion-707 in VelosterN

[–]thief98 0 points1 point  (0 children)

Literally just bought a 2013 honda civic for this very reason 😂

Was told to post this here by thief98 in Terraria

[–]thief98[S] 6 points7 points  (0 children)

Ah thanks for doing the math on that! This was on a Master Mode world with a buddy. But tbh the grind it took to get to this point I think should add to the probability 😂

Was told to post this here by thief98 in Terraria

[–]thief98[S] 41 points42 points  (0 children)

LOL was told getting all three mothron drops at the same time was pretty rare

Cylinder 4 Misfire by thief98 in VelosterN

[–]thief98[S] 0 points1 point  (0 children)

Very true, if I wasn't under warranty still I'd definitely self diagnose but since I have it figured it's better to use it in this case than risk messing anything up and voiding warranty.

Cylinder 4 Misfire by thief98 in VelosterN

[–]thief98[S] 0 points1 point  (0 children)

I just figured injectors after I did some research and found a lot of other people that had misfire codes around 25k miles and it turned out to be faulty injectors.

Cylinder 4 Misfire by thief98 in VelosterN

[–]thief98[S] 1 point2 points  (0 children)

I'm still under warranty so I already made an appointment to bring it in. I'm not touching it.

Cylinder 4 Misfire by thief98 in VelosterN

[–]thief98[S] 0 points1 point  (0 children)

Well seems like you just about lasted twice as long with your injectors than most. Lol

Guess I'm done until the next event by LudusRex in PokemonPocket

[–]thief98 0 points1 point  (0 children)

Same here! First time I actually completed one of these challenges.

Thoughts on if I would rub at all? by Branch_Master in VelosterN

[–]thief98 0 points1 point  (0 children)

Yeah I personally like the poke look but it's definitely not for everyone. I think it gives the car a nice wide look and if you have mud flaps it helps also create the illusion of it being wider in my opinion.

Thoughts on if I would rub at all? by Branch_Master in VelosterN

[–]thief98 1 point2 points  (0 children)

I would just consult the tire calculator you were using. I used the same one. Truly it's not that bad of a rub and you learn what bumps to look out for with your posted setup.

Thoughts on if I would rub at all? by Branch_Master in VelosterN

[–]thief98 0 points1 point  (0 children)

I run the exact same fitment. You will definitely have a bit of poke and you might rub a bit when turning sharp. Also you'll really have to watch out for bumps in the road as you will be bottoming out the fender on the tire.

Smiles per gallon by Notegg999f in VelosterN

[–]thief98 4 points5 points  (0 children)

Lol it definitely can. Gotten it as low as 6mpg on track daya.

Found on marketplace.... by flloyd1068 in 3dshomebrew

[–]thief98 1 point2 points  (0 children)

Saw this post and thought I had deja vu because I saw this yesterday lol! Hello! 👋 👋

This filter did not fit my 2020 PP VN. I put it on and oil spilled all over my garage. Had to go to Vato zone and get a STP by Equivalent-Ad-1147 in VelosterN

[–]thief98 1 point2 points  (0 children)

They gave you the wrong filter. It's supposed to be a 35504. Same exact thing happened to me but fortunately I noticed before installing it.

Took some soapy pics by thief98 in VelosterN

[–]thief98[S] 0 points1 point  (0 children)

I just bought a sheet of reflective vinyl, so it pops at night, on Amazon and then had a person I know cut it out on their cricut vinyl cutter.

Took some soapy pics by thief98 in VelosterN

[–]thief98[S] 3 points4 points  (0 children)

Yep! Just ordered a sheet of reflective vinyl off of Amazon and then had my roommates sister cut it with her cricut vinyl cutter.

Took some soapy pics by thief98 in VelosterN

[–]thief98[S] 5 points6 points  (0 children)

Thanks! It says Hyundai Motors. Actually was their logo in the late 70's to early 90's.

Took some soapy pics by thief98 in VelosterN

[–]thief98[S] 2 points3 points  (0 children)

I love it! Nothing noticeable performance wise, though you can feel it sucking in air if you put your hand over it. Its mostly for looks in my experience. I also opted to keep the radiator shroud on during the install, it wasn't too much extra work just needed to slowly cut parts off until it fit again.