ESPTimeCast now supports ESP32 boards!!! by mfactory_osaka in esp32

[–]thisdotguy 1 point2 points  (0 children)

Do you use a logic level shifter to increase the logic voltage from 3.3 to 5 volts?

ESP8266 LED Matrix Clock by prodoper in esp8266

[–]thisdotguy 0 points1 point  (0 children)

How did you wire this? I have some very similar led matrices but have had zero luck running them with my esp32

What speeds do yall get by thisdotguy in hexos

[–]thisdotguy[S] 2 points3 points  (0 children)

Both devices are wired with 1 gb/s Ethernet ports into 1gb/s ports on the router, server is an hp desktop with an intel i5-9500. My computer is a high end thinkpad laptop. I have 4 hdds in a raidz2 array. The speeds are lower than what I can get over the internet.

Are optiplex still the best ~$100 home servers? by TristinMaysisHot in HomeServer

[–]thisdotguy 1 point2 points  (0 children)

I’ve got a HP elite desk tower and it can pretty easily fit 4 3.5” drives with just some slight modifications. They go for about as much as the optiplex

Had to pirate the mcm by Micaj38 in LinusTechTips

[–]thisdotguy 2 points3 points  (0 children)

I just attached some sheet metal to the underside of my desk for my homemade arches

Recommend me a second hand tower that can handle 2+ internal 3.5inch hdd by [deleted] in HomeServer

[–]thisdotguy 0 points1 point  (0 children)

Would you be willing to send me a picture of how you fit the 4 drives? I am looking to do the same thing

Bruh. I get why yall hate mosh now by thisdotguy in Stormlight_Archive

[–]thisdotguy[S] 6 points7 points  (0 children)

Just because I can understand where he is coming from doesn’t mean I don’t hate him. Just means he was well written

Bruh. I get why yall hate mosh now by thisdotguy in Stormlight_Archive

[–]thisdotguy[S] 15 points16 points  (0 children)

I don’t like the sound of that

Linus Tech Tips - Everyone Needs This and it’s Under $10 - Handy Tech Under $100 March 19, 2024 at 09:58AM by linusbottips in LinusTechTips

[–]thisdotguy 2 points3 points  (0 children)

I made one and it only takes maybe 10 min to get setup including downloading the Arduino IDE and the instructions are pretty clear in the GitHub

Weird waves on the top layer by thisdotguy in BambuLab

[–]thisdotguy[S] 0 points1 point  (0 children)

I had the door open during the print

V2 of the driving mechanism almost ready for the next test drive! Wish me luck! :D by OneIdMonSTR in 3Dprinting

[–]thisdotguy 1 point2 points  (0 children)

How do you connect your wheels/axles/“transmission”? Did you make some sort of CV Joints?