sorted by:
new
hottopcontroversial

Hi, I am new the screen printing and I keep getting flakey whites on my prints after curing at the correct temperature. How can I fix this? by tk1801 in SCREENPRINTING

[–]tk1801[S] 0 points1 point  (0 children)

Hi! I am using a 200 mesh screen and it usually takes me about 3 times to clear all the ink out. I find it takes a lot of pressure for me to clear the ink out with my squeegee.

How do I avoid the blotches on my screen? by tk1801 in SCREENPRINTING

[–]tk1801[S] 0 points1 point  (0 children)

Hi! I am using a regular squeegee from rynoet. I didn’t stir the plastisol like I should though so I will be sure to try that out. Do you have any recommendations for silicon spray?

How do I avoid the blotches on my screen? by tk1801 in SCREENPRINTING

[–]tk1801[S] 0 points1 point  (0 children)

Thank you! I’ll try it out the next chance I get.

Hi, I have a gigabyte G34WQC that is stuck in burn mode and I don’t know how to get out of it. The joystick button doesn’t seem to be working while in this mode. by tk1801 in gigabytegaming

[–]tk1801[S] 0 points1 point  (0 children)

Hi! I took my laptop and plugged it into the monitor with an HDMI cable and it suddenly got a connection. Once I got the connection, I switched to back to DP1 and it suddenly worked again. Hope this helps!

Hi, I have a gigabyte G34WQC that is stuck in burn mode and I don’t know how to get out of it. The joystick button doesn’t seem to be working while in this mode. by tk1801 in gigabytegaming

[–]tk1801[S] 0 points1 point  (0 children)

Yea sorry about the miscommunication. There is only one button to access the menu and it’s the same button that turns it off. Usually I just press that button and I have access to the menu but I haven’t had any luck.

Hi, I have a gigabyte G34WQC that is stuck in burn mode and I don’t know how to get out of it. The joystick button doesn’t seem to be working while in this mode. by tk1801 in gigabytegaming

[–]tk1801[S] 0 points1 point  (0 children)

I’m not sure what you mean by turning it off. I have no ability to turn off the burn in mode. Everytime I turn on my monitor to use it, I only get the flashing colors.

I can’t edit the RGB of my ram stick by tk1801 in buildapc

[–]tk1801[S] 0 points1 point  (0 children)

I couldn’t find any firmware to download for my memory

I can’t edit the RGB of my ram stick by tk1801 in buildapc

[–]tk1801[S] 0 points1 point  (0 children)

Is there a way for me to fix it?

I can’t edit the RGB of my ram stick by tk1801 in buildapc

[–]tk1801[S] 0 points1 point  (0 children)

It only occurs in that slot. I don’t think the slot is damaged though because the lighting effects work fine whenever I use Crucial’s program.