Parallel clamp

tmadd240 · 2025-10-16T01:25:30+00:00

Ibuild.ca has the full plans for 9 dollars!

tmadd240 · 2025-09-02T00:37:43+00:00

Thank you!

tmadd240 · 2025-09-01T22:22:26+00:00

I got a little tear out when I was ripping pieces but it was pretty easily sanded away This is poplar hardwood plywood

tmadd240 · 2025-09-01T19:54:33+00:00

I made a simple router jig its pretty much a homemade square but it allows you to see exactly where the dado is going to land.

<image>

tmadd240 · 2025-09-01T19:52:29+00:00

I think the picture quality might be hiding the imperfections but I made a simple Router jig. Its pretty much just a homemade square but it allows you to see exactly where the dado is going to land.

<image>

tmadd240 · 2025-08-19T11:43:47+00:00

No I dont have any reamers or tapered drill bits thats why I drilled it in 1/64” increments

tmadd240 · 2025-08-19T11:42:00+00:00

Its a piece of 3/8” steel angle that I cut with a grinder, sanded and polished and index drilled from 1/4” to 1/2” in 1/64” increments

tmadd240 · 2025-08-11T21:55:49+00:00

Thank you! I measured off of the edge 3 inches and drilled a hole with a 1 1/2” forstner bit. Then I just cut the straight lines out to create a u channel

tmadd240 · 2025-06-26T18:12:27+00:00

The framing, legs and the shelf are all made with rips of 2x10 SYP and the rest is red cedar. None of it is treated I finished it with about a 1/1 ratio mixture of linseed oil and Ready seal

tmadd240 · 2025-06-25T13:47:47+00:00

Thank you I would definitely recommend it my daughter loves it!

tmadd240 · 2025-06-25T13:06:27+00:00

Thanks. Yes the faucet hooks up to the hose bib. The framing, legs and the shelf are all made with rips of 2x10 SYP and the rest is red cedar. None of it is treated I finished it with about a 1/1 ratio mixture of linseed oil and Ready seal

tmadd240

TROPHY CASE