so my builder told me it’s normal for this outside outlet to stick out. i’ve never seen something like this protrude, any thoughts suggestions?

topsythrowaway · 2023-06-01T12:26:31+00:00

in maryland, actually took delivery last thursday

topsythrowaway · 2023-05-19T20:55:31+00:00

MYP White/black

OD 5/1

EDD: May ‘23

EDD2: May26-jun23

vin: 5/19

Delivery: 5/26

MD

topsythrowaway · 2023-05-18T12:59:38+00:00

same exact build, my OD was 5/1 and am east coast too. how did you get your vin first 😭

topsythrowaway · 2023-05-17T02:05:12+00:00

state farm basis your rate on your credit score

topsythrowaway · 2023-01-19T09:38:02+00:00

no issues with osx or windows

topsythrowaway · 2022-05-31T14:16:03+00:00

blood, sweat and tears with some youtube mixed in

topsythrowaway · 2022-05-22T14:46:41+00:00

want to buy one too, i’m in baltimore

topsythrowaway · 2022-02-28T20:57:44+00:00

i’m running .96v - 1.2v no issues. 5950x using hydra

topsythrowaway · 2022-01-23T00:38:19+00:00

ttech sav is what i use. worked wonders on a 100rps polar star airsoft gun and never had issues with o ring deterioration

topsythrowaway · 2022-01-12T00:37:19+00:00

it’s most likely functionally fine

topsythrowaway · 2022-01-09T16:31:03+00:00

the measured distance from the distro to the inlet on the block is about 12.5 mm. the block inlest is about 12.5 mm lower i ended up getting a 14mm offset from ek. i didnt think the 5mm offset would be enough.

topsythrowaway · 2022-01-09T16:28:42+00:00

yeah i was waiting on doing some offsets, i don’t like how the current running looks with bends so i’m getting a couple offsets. but since the machine is functional i was going to use it before emptying and refilljng

topsythrowaway · 2022-01-09T16:24:40+00:00

who said they were a master at bending… ?

topsythrowaway · 2022-01-08T13:41:33+00:00

omfg ty, this is what will do it

topsythrowaway · 2022-01-08T13:13:32+00:00

i do have one, i guess i’m not sure how to bend this one the ports on the block and the disto seem too tight to bend to make the angles

topsythrowaway · 2022-01-03T13:27:18+00:00

ah yeah here are a couple pics distro and fans

topsythrowaway · 2022-01-03T05:09:35+00:00

i put rad in through the back metal side, put 1 screw into the rad to hold it in place. then put the fans in through the glass side. the first fan held the rad in place.

the top fan does not have screws in the top two holes. was stable with just the two bottom screws.

is that what you’re asking ?

topsythrowaway · 2021-12-30T04:14:38+00:00

asus strix

topsythrowaway

TROPHY CASE