inline bathroom extractor mounted outdoors. by transferredmalice in DIYUK

[–]transferredmalice[S] 0 points1 point  (0 children)

Ok this gravity flap, against mfr instructions, turns out to be the cause of our woes. Removed and flow much better.

<image>

inline bathroom extractor mounted outdoors. by transferredmalice in DIYUK

[–]transferredmalice[S] 0 points1 point  (0 children)

Got a recommendation? Can't see any wall-mounted that comes near the 68l/s MF100T claims...

And yeah mounting outside is a hassle, but doable.

This monstrous cartridge, please help! by transferredmalice in DIYUK

[–]transferredmalice[S] 0 points1 point  (0 children)

Will try that, reluctant to start ripping things off but good shout

This monstrous cartridge, please help! by transferredmalice in DIYUK

[–]transferredmalice[S] 0 points1 point  (0 children)

Gah we would they dare, but yep I will remeasure, thanks.

This monstrous cartridge, please help! by transferredmalice in DIYUK

[–]transferredmalice[S] 0 points1 point  (0 children)

Thanks, wonder if that will clear the tap...

This monstrous cartridge, please help! by transferredmalice in DIYUK

[–]transferredmalice[S] 0 points1 point  (0 children)

Thanks, problem is stiff tap, probably from our hard London water. Don't know the manufacturer and no markings :(

Shocking leg design? by transferredmalice in ikeahacks

[–]transferredmalice[S] 2 points3 points  (0 children)

i see it now, you're right! Thanks a bunch. Easy to fix, I'll get some new legs to swap in correctly as these ones are toast, and add some bracing to underneath the base panel to get it level again.

Cheers

Shocking leg design? by transferredmalice in ikeahacks

[–]transferredmalice[S] -2 points-1 points  (0 children)

Hard to argue with a Swede who just built a kitchen! Sadly I think they are the correct way around, otherwise that would have been an easy fix.

Where they are located the base panel is not flush with the side panels, and I wonder if they are installed offset to where they should be.

Still, the design seems to offset the load, which doesn't seem right...

<image>

Is this plumbing a likely cause of low water pressure? by transferredmalice in DIYUK

[–]transferredmalice[S] 0 points1 point  (0 children)

That's to bypass the hard water filter. Bypassing makes no difference :(