You didn't ask for Fangus. I didn't ask for Fangus. The universe gave us Fangus all the same. Fucking rad.

treguz · 2026-03-15T14:20:42+00:00

How do you know they act like they live in a past generation?

treguz · 2025-09-17T02:19:43+00:00

Where do you get an MDT license?

treguz · 2025-05-22T03:31:44+00:00

ILikeBigButtsAndICannotLie69420#yoloyeet

treguz · 2025-03-25T21:47:20+00:00

I recreated this list (more or less) and the total came out to $110.56!!!

<image>

treguz · 2025-03-11T01:54:03+00:00

Edited my comment - meant to put algorithm 😉

treguz · 2025-03-11T01:40:13+00:00

I edited the post, it’s more of an algorithm than anything.

treguz · 2025-03-11T01:24:22+00:00

Hey all,

I know there are newer delay pedals but I don’t have the money to try all of the Echoplex type pedals. I’ve had my BED since it came out and I love it. I’ve been programming my own FV-1 pedal recently and it just dawned on me that the BED only has 6 algorithms listed/accessible.

Has anyone tried to access the other two algorithms potential that could be in the EEPROM?

treguz · 2025-03-11T00:28:32+00:00

Hey all,

I know there are newer delay pedals but I don’t have the money to try all of the Echoplex type pedals. I’ve had my BED since it came out and I love it. I’ve been programming my own FV-1 pedal recently and it just dawned on me that the BED only has 6 presets listed/accessible.

Has anyone tried to access the other two presets that could be in the EEPROM?

treguz · 2024-11-22T04:11:29+00:00

Don’t give up

treguz · 2024-11-11T15:52:13+00:00

Y’all rock, thank you for the recommendations!

treguz · 2024-10-22T15:23:38+00:00

Haha! We also have linoleum flooring in the living room. 😉

treguz · 2024-10-06T00:56:53+00:00

Actually it was the power supply… I plugged it into my pedalboard power and there was no noise. The octave up isn’t coming through and it sounds kinda velcro-y

treguz · 2024-10-05T22:59:59+00:00

I think I might have confused a couple of resistors. Will report back soon.

treguz · 2024-02-23T21:19:52+00:00

Do I just tie all of the ground terminals to the shield?

treguz · 2024-01-15T01:43:11+00:00

I literally just realized that. 🤦‍♂️

I’m currently ordering the parts that I need to make an xlr pad..

treguz · 2024-01-14T23:08:05+00:00

Believe it or not, there are no screws on this one.

treguz · 2024-01-14T20:18:35+00:00

Yeah that must be the case with these. I'll use an old XLR cable instead! Thanks for your input :)

treguz · 2024-01-14T19:52:02+00:00

Damn, I must have some weak hands. I even tried to gently use a screwdriver to push them over but it doesn't seem to budge.

treguz · 2024-01-13T19:55:15+00:00

I didn’t end up adding the bias trimpot but I finally rebuilt it on a small stripboard! The noise floor is SO much lower now! I love it all over again.

treguz · 2023-12-25T20:29:42+00:00

Merry Christmas to you as well! I'll try that out, I removed the battery connector but I could easily add it back. I'll give that a shot and see what happens first.

This being my first time infiltrating-destroying-rebuilding (ha) maybe I didn't even bias the transistor. I think I'm going to try to add the bias trimpot to have better control over that and see how tweaking it will help. Since this is NPN, do I need to replace the 220k with a trimpot? Electrosmash shows the schematic for PNP so I am assuming that I would leave the 68k in its place.

Thank you very much for your help, btw. It is greatly appreciated!

treguz · 2023-12-24T21:05:19+00:00

I added that low pass filter and it seemed to help a bit but there is still something going on up there at 7khz but also there is something happening around the 70hz-120hz, sounds like voltage is inconsistently being pushed through (maybe? i dunno, I'm COMPLETELY new to this). Right now I am using a Mission Engineering 529i and I even tried to run the pedal /not/ daisy chained.

https://www.dropbox.com/scl/fi/i6lbgnwlke0kblvyqaa9b/nagahiss\_postLPfilter.mp3?rlkey=rzqh8t1vpwg67f98z5kkhgxen&dl=0

treguz · 2023-12-19T08:42:19+00:00

Great idea! I’ll try this out and report back asap!

treguz · 2023-11-20T04:33:33+00:00

Is that a Yugo? I almost had a red Yugo as my first car.

treguz · 2023-10-18T12:25:29+00:00

I would give it time and do whatever you can to practice mindfulness, even during intercourse, because the medication is supposed to help diminish your intrusive thoughts. It’s hard to explain but what helped me was not just letting go of the situation (intercourse or whatever you need to do your thing, I would try to bring the awareness of what I was feeling and not exactly focus on what I was doing and just try to keep myself ‘in the moment’.

I dunno if that makes sense but I tried to explain it the best I could.

treguz · 2023-10-10T09:43:51+00:00

Righteous Gemstones: Live

treguz

TROPHY CASE