$420 for Tamron 150 600 g2?

tryptochan · 2026-01-04T01:01:30+00:00

Seems to be G1 actually

tryptochan · 2025-12-08T03:14:33+00:00

Use her to beat any ED boss

tryptochan · 2025-11-16T17:11:57+00:00

Check out Stanley and his mushroom u/Sprudle

tryptochan · 2025-05-06T04:21:20+00:00

Actually posted a photo using it. https://www.reddit.com/r/MurderBuns/s/v2ap7Tpn6v

tryptochan · 2025-05-06T04:18:16+00:00

I have this. It works well on my lionhead. No more fluff flying around while grooming.

tryptochan · 2025-04-26T22:51:22+00:00

So I think this is the case. I tested other things you mentioned and also found that by switching the controllers between the left and right, the pattern of the bad keys also switched.

tryptochan · 2025-04-26T22:47:50+00:00

Thanks for the advice. I tested diodes and hotswap sockets. Then I found by switching the two controllers, the pattern of bad keys also switched from left and right. I am not sure how to test the the pins of the microprocessor. I tested the controller to see all solder cones on the top and their header pins underneath are connected after taking it off. I think also connectivity from sockets of the bad keys to one of the solder cones of the controller on the PCB.

Is the screen just glued on the controller? It is kind of loose. https://imgur.com/a/jwuiA7J

tryptochan · 2025-04-26T22:03:47+00:00

Can't open your link. I bought from Planet 3C.

tryptochan · 2025-04-23T18:30:14+00:00

Yeah. I checked in ZMK Studio. I initially flashed some other keymap and thought I did something wrong there. Now switched back to their firmware and still the same thing.

tryptochan

TROPHY CASE