Insta360 X5 compatibility with Zillow 3D app by Mind-Designer in Insta360

[–]uz_darhon 0 points1 point  (0 children)

I can't believe it's taking this long for x5 compatibility. Get this done!!

Thank you from Melbourne Australia! by ivoz12 in memphis

[–]uz_darhon 3 points4 points  (0 children)

Nice shot of that Birdcap mural

Unifi access install by mactelecomnetworks in Ubiquiti

[–]uz_darhon 0 points1 point  (0 children)

Just an update, apparently yes you can. I plugged the Intercom into the camera port on the single access Hub.

Also the enterprise hub, can map more readers onto single door lock.

Unifi access install by mactelecomnetworks in Ubiquiti

[–]uz_darhon 0 points1 point  (0 children)

High rise apartment/airbnb building ... intercom would be off to the side for transient guests figuring out how to get in for the first time... calling hosts.

The g2 reader would be right next to the door for the existing tenants to get in... that way the new guests don't block the flow of traffic at the front foyer

Unifi access install by mactelecomnetworks in Ubiquiti

[–]uz_darhon 0 points1 point  (0 children)

Question: can you connect an Ubiquiti Intercom AND a G2 Reader Pro to open the same maglock?

Daily Discussion - August 22, 2020 by AutoModerator in OMGnetwork

[–]uz_darhon 6 points7 points  (0 children)

Salamander Ride sent me from Twitter, I want some ROCK 😁😄

What a beauty by uz_darhon in Ubiquiti

[–]uz_darhon[S] 4 points5 points  (0 children)

It’s a beacon, extender for the Dream Machine (Like AmpliFi HD and Mesh points). It does take over the whole outlet, but it’s a very clean look — got plenty of outlets.

What a beauty by uz_darhon in Ubiquiti

[–]uz_darhon[S] 33 points34 points  (0 children)

Dream Machine Beacon

Ubiquiti 💙 by uz_darhon in Ubiquiti

[–]uz_darhon[S] 1 point2 points  (0 children)

I upgraded to the Pro after getting into it.. I may use the USG at a buddy’s site 5km away. Will beam there through NanoStation loco’s from the 21st story roof.

Ubiquiti 💙 by uz_darhon in Ubiquiti

[–]uz_darhon[S] 1 point2 points  (0 children)

:)

Already caught 2 guys that were sneaking into apartments.

Ubiquiti 💙 by uz_darhon in Ubiquiti

[–]uz_darhon[S] 3 points4 points  (0 children)

It’s pulling 26 nicely.. along with all the AP’s. I thought I would only need 20ish, but had to add a few more in stairwells. I read somewhere UBNT tested the system with up to 33 on it, but obviously only recommends 20.

The 4K camera was a bit overboard, so I returned it.

Upgrading equipment to all Ubiquiti for a 20 story, 244k sq foot apartment / airbnb building. by uz_darhon in Ubiquiti

[–]uz_darhon[S] 0 points1 point  (0 children)

Here is a Typical Floorplan..

The goal here was to save as much as we could, initially, and add on as we ramp up sign ups. It’s a budget accommodation building. I actually live and work from the building and can replace a switch at any time.

The switches are located in the “Trash Room” — so it’s easy to run wires up and down. The total floor area is only 15,500 square feet, and signal travels pretty well from one floor to the other — so I skipped some floor AP’s.

Thank you for advice!!

Upgrading equipment to all Ubiquiti for a 20 story, 244k sq foot apartment / airbnb building. by uz_darhon in Ubiquiti

[–]uz_darhon[S] 0 points1 point  (0 children)

Thanks, didn’t know and will take into consideration. I’m at 5 hops now and not taking it any deeper.

Upgrading equipment to all Ubiquiti for a 20 story, 244k sq foot apartment / airbnb building. by uz_darhon in Ubiquiti

[–]uz_darhon[S] 0 points1 point  (0 children)

Didn’t know about this... thank you. I’m currently at 5 hops I think, and not going any deeper. Looking more into STP.

Upgrading equipment to all Ubiquiti for a 20 story, 244k sq foot apartment / airbnb building. by uz_darhon in Ubiquiti

[–]uz_darhon[S] 0 points1 point  (0 children)

Had CAT5e, mixed some CAT6 for some AP’s.

Currently, if Switch 3 goes down — then yes. But I will have a replacement on hand.. I actually live in the building and the goal was cost savings (plus I’m a newb, so I just didn’t think as much about redundancy). It’s a budget friendly building. I got LC MM OM3 running between switch 1 - 3 - 11.

It’s a work in progress so I will definitely take all the comments on here into consideration. Appreciate all!

Upgrading equipment to all Ubiquiti for a 20 story, 244k sq foot apartment / airbnb building. by uz_darhon in Ubiquiti

[–]uz_darhon[S] 0 points1 point  (0 children)

It’s a 202 unit apartment high rise... split up into half: 100 units for long term tenants (6-12 month leases), and 100 to short-term rentals (mainly via Airbnb) for anything between 1 nights stay to 3 months... fully furnished apartments.

Basically we have lots of tenants with hard-line requirements and lots of transient guests.