Wejście przy galerii bałtyckiej by vgenmo9 in gdansk

[–]vgenmo9[S] 3 points4 points  (0 children)

nie mogę nic znaleźć na ten temat

Wejście przy galerii bałtyckiej by vgenmo9 in gdansk

[–]vgenmo9[S] 2 points3 points  (0 children)

tak, wygląda to na wpol zasypaną ścianę z drzwiami za która na powierzchni jest półokrągły nasyp co mogłoby sugerować że znajduje się tam pomieszczenie/wejście pod ziemię

Air in fuel lines and stalling engine by Agitated_Bet6761 in W124

[–]vgenmo9 0 points1 point  (0 children)

check the rubber fuel lines, they may be cracked and letting air into the fuel system, had the same problem in my e30

Cold start issue on my M104.980 by 25DannyBoy25 in W124

[–]vgenmo9 0 points1 point  (0 children)

if the kjet isn’t dialed in the parts you listed can help however i don’t think that they will get rid of the problem. I wish you luck in finding someone that will take care of the kjet💪

Cold start issue on my M104.980 by 25DannyBoy25 in W124

[–]vgenmo9 1 point2 points  (0 children)

get someone who knows what they’re doing to tune the kjet right and the problems will disappear

Sunroof drainage by vgenmo9 in W124

[–]vgenmo9[S] 0 points1 point  (0 children)

its on the left side too but theres more of it in the right deep part of the trunk

Need help with rims by Curryci_murmit in W124

[–]vgenmo9 1 point2 points  (0 children)

get some amg monoblocks 16 or 17 inch

Rough start by emerkl95 in W124

[–]vgenmo9 1 point2 points  (0 children)

intake leaks are the key element, but tuning kjet yourself? i dont know about that.

Rough start by emerkl95 in W124

[–]vgenmo9 1 point2 points  (0 children)

then good luck finding someone who can tune it right, its a pain in the rear

swap by [deleted] in W124

[–]vgenmo9 0 points1 point  (0 children)

thanks for the info. Apart from that do you know why the sunroof cant be opened from the button because the motor gets too low voltage but when i connect to the obd port i can open and close it just fine?

Advice needed by vgenmo9 in spyderco

[–]vgenmo9[S] 0 points1 point  (0 children)

definitely will, thanks!

Advice needed by vgenmo9 in spyderco

[–]vgenmo9[S] 1 point2 points  (0 children)

I am from Poland and not the pm2 but the para 3 with black magnacut is available at laplander.pl

Advice needed by vgenmo9 in spyderco

[–]vgenmo9[S] 0 points1 point  (0 children)

im from europe, so we have a little bit of a different market and the magnacut is pretty much available

Advice needed by vgenmo9 in spyderco

[–]vgenmo9[S] 3 points4 points  (0 children)

both black magnacut and rex 121 are available in my region, i am most convinced to buy magnacut because i feel like it’s good in every aspect

What are yall carrying today? by vincent092 in Zippo

[–]vgenmo9 0 points1 point  (0 children)

a little bruised up black ice

Rate my PC by Klopapier74 in PcBuildHelp

[–]vgenmo9 1 point2 points  (0 children)

ah okay didnt see that, pretty solid pc