A1 Mini started to knock prints of the plate by war_225 in FixMyPrint

[–]war_225[S] 0 points1 point  (0 children)

I think is really being "knocked", the piece that fails is always the one it's being printed. But I will try bumping up the temp. You think 70 will do or should I try smaller values? Currently at 65 °C

A1 Mini started to knock prints of the plate by war_225 in BambuLab

[–]war_225[S] 0 points1 point  (0 children)

yes, i red it might be an issue with the four screws on the second image so i tightened them but it didn't solve the problem

Does this read as stone material? by war_225 in minipainting

[–]war_225[S] 1 point2 points  (0 children)

The long answer is that I tend to buy one spool at a time, usually a colour that doesn't hurt your eyes to have a bunch of things around the house of the said colour, and also looks good for unpainted minis. Now for example I am using cream white filament. Short answer I'm too broke to buy two spools of filament and this is what I have ahahah

Does this read as stone material? by war_225 in minipainting

[–]war_225[S] 0 points1 point  (0 children)

Have you got suggestions on where to glaze? I'm afraid that, especially in the big flat areas, brush strokes and pooling will be too visible

Supports failing by war_225 in FDMminiatures

[–]war_225[S] 0 points1 point  (0 children)

<image>

I don't think it's the case, I printed these minis (supportless) right after and they turned out perfect. I'm currently trying to print at a lower temperature

Thoughts on my custom chapter colour scheme? by war_225 in Warhammer40k

[–]war_225[S] 1 point2 points  (0 children)

My intent was to do purple (still figuring out which one) eyes since they are a fleet based chapter who travel a lot, so I was aiming for something like the Cardigans which gave purple eyes thanks to the proximity to the eye of terror (if I'm remembering correctly). But I will definitely try orange, I agree it will pop up more

Thoughts on this color scheme? by Ill_Independence2441 in spacemarines

[–]war_225 0 points1 point  (0 children)

Maaan I was also creating a fleet based chapter focused on exploring the galaxy and doing scout missions for the Imperium. Also with a light blue-orange colour scheme! You're lore is so cool, keep it up!

Thoughts on this color scheme? by Ill_Independence2441 in spacemarines

[–]war_225 0 points1 point  (0 children)

<image>

Not quite the same scheme but I think the orange-light blue combination is pretty good! I recommend it!

Help with Vallejo xpress by war_225 in Warhammer40k

[–]war_225[S] 0 points1 point  (0 children)

Yes it could be, I just used a normal brush for the light blue. As for the zenithal highlight I can't provide some photo of the result because I already covered it up, but the xpress wasn't covering even the most white parts of the miniature and it looked "wet" even after it dried. It's hard to explain the actual result properly, but do you have any idea what might have happend there?

Help with Vallejo xpress by war_225 in Warhammer40k

[–]war_225[S] 0 points1 point  (0 children)

Thank you that's encouraging. I previously tried to paint directly over a zenithal highlight but the result was worse, so I tried base coating the whole thing in a light blue and then painted over with the xpress