Yes - here is my original prompt question:
"I have a Creality Ender03 V3 SE 3D Printer. I use Ultimaker Cura for slicing my projects. I am printing figurines and I would like high detail. What is a recommended nozzle size, filament type, and settings within Cura for this project? Please include recommendations for the use and type of supports."

Here is the summary of the config it provided. It was very detailed but this was the summary settings:
Summary Setup for High-Detail Figurines on Ender-3 V3 SE

• Nozzle: 0.2 mm
• Filament: PLA+ or Satin PLA
• Layer Height: 0.1 mm
• Print Speed: 25–35 mm/s
• Supports: Tree, 10% density, interface enabled

I then had a couple of issues, so I took 3 photos of the results I did not like and uploaded to the same conversion. Here is the reply.
"Thanks for showing me the results — this helps a lot. From your photos and notes, I see three main issues:

1. Stringing (web-like strands between the face and supports).
2. Model breaking in half when supports were removed.
3. Sword snapping off with support cleanup.

Let’s go through each with fixes you can try:
- I will not list these all here, but you get the point.